TheMAX232deviceis a dualdriver/receiverthatincludesa capacitivevoltagegeneratorto supplyTIA/EIA-232-Fvoltagelevelsfroma single5-Vsupply.EachreceiverconvertsTIA/EIA-232-Finputsto 5-V TTL/CMOSlevels.Thesereceivershaveatypicalthresholdof 1.3 V, a typicalhysteresisof 0.5V, and can accept±30-Vinputs.EachdriverconvertsTTL/CMOSinputlevelsinto TIA/EIA-232-Flevels
The ST232 is a 2 driver, 2 receiver device following EIA/TIA-232 and V.28 communication standard. It is particularly suitable for applications where ±12 V is not available. The ST232 uses a single 5 V power supply and only four external capacitors (0.1 µF). Typical applications are in: portable computers, low power modems, interfaces translation, battery...
CD40175BE Digital BCD in decimal, CMOS DIP16 Decoder Flip Flop
Texas Instruments 4000 Series Toggles and Latching Circuits
Texas Instruments Series 4000 Series CMOS Logic Family of Toggles and Latching Circuits
CMOS 4000 logic family, Texas Instruments
CMOS family devices
Extended operating voltage range: 3 to 18 V
Pre-programmed Globally Unique, 48-bit Node Address
Compatible with EUI-48™ and EUI-64™
Single Supply with Operation Down to 1.7V
Low-Power CMOS Technology:- Read current 1 mA, max.- Standby current 1 µA, max.
2-Wire Serial Interface, I2C™ Compatible
Schmitt Trigger Inputs for Noise Suppression
The AD597ARZ is a monolithic temperature Set-point Controller which has been optimized for use at elevated temperatures such as those found in oven control applications. The device cold junction compensates and amplifies a type J or K thermocouple input to derive an internal signal proportional to temperature. The internal signal is then compared with an...
shift register chip of the is used a lot by hobbyis because of its wide availability, good speed and simplicity. Just plug it on an arduino like shown in the tutorials and youi have 8 more outputs, put two and you have 16 more outputs ! (up to a lot of them actually, with only three pins !)
The MAX6969 serial-interfaced LED driver provides 16 open-drain, constant-current-sinking LED driver outputs rated at 5.5V. The MAX6969 operates from a 3V to 5.5V supply. The MAX6969 supply and the LEDs' supply or supplies can power up in any order. The constant-current outputs are programmed together to up to 55mA using a single external resistor. The...
Microcontrôleur ARM; SRAM: 8kB; LQFP48; Flash: 32kB; 1,8÷3,6VDC
ARM Cortex-M0 Microcontrollers, NXP
The NXP family of ARM Cortex-M0 based, low-cost 32-bit MCUs are designed for 8/16-bit microcontroller applications. They offer high performance, low power, simple instruction set and memory addressing together with reduced code size compared to existing...
The RTC module is specifically designed for Raspberry Pi / Aruino compatible. It communicated with Raspberry Pi through I2C bus. There is a Maxim DS1307 and CR1220 button cell on the board to keep the real time for a
planar passivated sensitive gate 4-quadrant TRIAC for general purpose bidirectional switching and phase control applications. This series TRIAC is intended to be interfaced directly to microcontrollers, logic integrated circuits and other low power gate trigger circuits.