This GSM module is a breakout board and minimum system of SIM900 Quad-band GSM/GPRS module. It can communicate with controllers via AT commands (GSM 07.07 ,07.05 and SIMCOM enhanced AT Commands). This module support software power on, reset, data transfer and audio.
The 3G shield is based on SIM5216E module. The SIM5216 series is Multi-Band HSDPA/WCDMA/GSM/GPRS/EDGE module solution which supports HSDPA up to 3.6Mbps for downlink data transfer. The 3G shield can be used for 3G communication, it is controlled via AT commands and fully compatible with Arduino.
This module power supply of 5V, computer debugging USB to TTL serial port. 800MA power supply output current , TTL serial port compatible with 3.3V and 5V MCU, the MCU can be connected directly.
IPX antenna interface can switch PCB antenna, glue stick antenna and sucker antenna.
SIM800L 4 frequency data communications, globally available.
LoNet is a GSM and GPS two-in-one function module. It is based on the latest GSM/GPS module SIM808 from SIMCOM, supports GSM/GPRS Quad-Band network and combines GPS technology for satellite navigation.
It features ultra-low power consumption in sleep mode and integrated with charging circuit for Li-Ion batteries, that make it get a super long standby time...
The GPRS (General Packet Radio Service) Shield is a new nonvoice value added service that delivers GSM/GPRS 850/900/1800/1900MHz performance for voice, SMS, Data, and Fax in a small form factor and with low power consumption. It is controlled via AT commands (GSM 07.07 ,07.05 and SIMCOM enhanced AT Commands), and fully compatible with Arduino.
This is an adapter plate kit for Raspberry Pi board to SIM900 module, which allows users to easily connect Raspberry Pi and SIM900 module and extends GSM / GPRS function for Raspberry Pi to achieve additional features, such as message receiving and sending, phone call dialing and answering and GPRS wireless data communication, etc.
SIM900 board and...