Power and Energy

Available
Power and Energy

CPT-C5 converter

ENESESCPTC5
€17.00
CPT-C5 is a power converter module output 5V. Low heat, adopt synchronous rectification technology (5A long-term without any additional cooling measures).
 2
Available
Wireless Connectivity

Smart Socket WiFi Orvibo S20 (EU Plug)

RELORVS20EU
€22.50
Instantly convert any plug into a connected and intelligent outlet with a convenient timer function that works both on your smart phone and has a manual control knob. Perfect for lighting and other appliance with pre-set ON/Off functions. Control devices from anywhere
 2
Available
Electronics

Battery Protection Bags (30x23cm)

BAGJANLIPO
€5.15
This is a fireproof bag, designed to stop and contain any fire caused by incorrectly charging or poorly functioning lipo packs.
 2
Available
Display

Battery Level Display

LCDJANBATLVL
€4.58
This is battery level display module based on battery style digital tube LED. The 5 - segment LED inside is red light and the frame is green light. There is driver chip TM1651 onboard, so the control interface is simple, just two signal lines and VCC / GND. It can be used to display the battery power.
 2
Available
Electronics

Battery Holder - 2xAAA

HOLITE2AAA
€2.00
The 2xAAA Battery Holder puts a nice finishing touch on your battery powered project. It can provide about 3V(2x1.5V) Voltage power for your project. It is series connection.
 2
Available
Electronics

Micro Booster (Micro USB or solder pads,...

ENEJANBSTMUSB
€2.58
The module supports MicroUSB input, a USB charger or mobile power supply can easily get to it 9V, 12V, 15V, 18V, 24V, easy to use. Wide input and output voltage, high conversion efficiency.
Out of stock
Electronics

1.5W Solar Panel 81X137

Seeed Studio
ENESES15W
€8.28
This is a custom solar panel, which mates directly with many of our development boards and has a high efficiency at 16%. Unit has a clear epoxy coating with hard-board backing. Robust sealing for out door applications!
Out of stock
Electronics

Micro USB Power cable 2A w/Switch

CABMICUSBSW
€4.67
It’s very inconvenient to remove off the USB power cable from raspberry pi, it also damages the main board of Raspberry pi. This cable can protect the USB jack, and your RPI board. It can also used for your any other digital devices, for example, it can be power off when your charge your phone.
 2
Available
Electronics

2W Solar Panel 110x136

Seeed Studio
ENESES2W
€10.00
This solar panel is made of single-crystal material that performs high solar energy transformation efficiency at 17%. It has a fine resin surface and sturdy back suitable for outdoor environments. A 2mm JST connecter is attached to the penal, which makes it perfect to team up with most of our can-use-solar-power-supply boards, like Seeeduino...
Available
Power and Energy

3W Solar Panel 145x145

Seeed Studio
ENESES3W
€14.30
This is a custom solar panel, which mates directly with many of our development boards and has a high efficiency at 16%. Unit has a clear epoxy coating with hard-board backing. Robust sealing for out door applications!
Available
Electronics

1W Solar Panel 110X60-6

Seeed Studio
ENESES1W
€6.25
Need a clean energy source for your project? Check out this compact, high quality, high output endurable solar panel. This solar panel mates directly with many of our development boards and has a high efficiency. Unit has a clear epoxy coating with hard-board backing, provides an efficient and waterproof surface for the panel application on out-door...
 2
  • Reduced price / -€2.90
Available
Electronics

Energy Shield

Seeed Studio
ASHSESENESH
€18.00 €20.90
Energy Shield is a LiPo battery based power shield that keeps your project alive. It keeps its battery charged whenever an available power source exists. It accepts a wide range of power sources, from common solar cells via JST connector and USB via USB port on microcontroller, to 9V and 12V DC adapters via DC Jack on your Arduino. Meanwhile it can not...
Product added to wishlist
Product added to compare.