Your cartThere are no more items in your cart
Double Base - (Wemos D1 Mini)
For your small prototyping.
- size: 54.20mmx34.50mm
- Prix d'achat
- Mémoire Flash (programme)
- Display Type
- Fréquence Radio
- Résolution d'affichage
- Colonne de rangement
- Compatibilité avec les cartes
- Code Fabricant
- Tension en entrée
- Type de composant
- Google Product Type
- Couleurs d'affichage
- Zone de stockage
- Etage de rangement
Customers who bought this product also bought:
This wireless door switch is a great addition to your project. With its included batteries, just put it on your door using the given tape and voilà, a new door sensor !
Useful (ie. mandatory :)) fume extractor for all your soldering job !
GY-BME280 is a Breakout Board featuring a Bosch Sensortec BME280 Temperature, Humidity & Pressure Sensor. The board has selectable I2C address jumper (solder link GS2), I2C pull-up resistors, 7 pin header 2.54mm, and two mounting holes 3.5mm. Default setting of the board; single power rail Vdd=Vdd_IO (solder link GS1), pull-ups resistors (R2, R3) 10k,...
Flush diagonal cutters used for jewelry making, watch making, fine metal work, and electronics.
This little pack contains a good base to begin with Arduino or other micro-controllers.
8cm x 12cm protoboard with 2.54mm spacing
Latest Arduino sensor Shield V5.0 reserves advantages of Arduino Sensor V4.0,such as lamination design, PCB immersion god process, and main board extend all the figures and analog interfaces of Arduino controller. I2C interface, 32 steering engineer controller interface, Bluetooth module communication interface ,SD card module communication interface,...
“An open-source firmware and development kit that helps you to prototype your IOT product within a few Lua script lines” Based on ESP8266 ESP12E wifi board, on-board USB-TTL support directly flashing from USB port, also on-board power circuits and all IOs setup.
This solar panel is made of single-crystal material that performs high solar energy transformation efficiency at 17%. It has a fine resin surface and sturdy back suitable for outdoor environments. A 2mm JST connecter is attached to the penal, which makes it perfect to team up with most of our can-use-solar-power-supply boards.
The LiPo Charger is extremely affordable and easy to use. No programming is required. Plug it in and it works. The internal charger IC handles all the power flow between the various components.