Your cartThere are no more items in your cart
ProtoBoard Shield - (Wemos D1 Mini)
For your small prototyping.
- size: 28.35mmx25.69mm
Customers who bought this product also bought:
Small Sealed Membrane 4X4 button pad with sticker
Highly integrated module popularly used for entry detection, it complies with microcontroller or DC loads.
Latest Arduino sensor Shield V5.0 reserves advantages of Arduino Sensor V4.0,such as lamination design, PCB immersion god process, and main board extend all the figures and analog interfaces of Arduino controller. I2C interface, 32 steering engineer controller interface, Bluetooth module communication interface ,SD card module communication interface,...
This is a breakout board based on TXB0108 IC, the chip can provide bidirectional level shifting from any voltage to any voltage conversion, direction can be auto detected.
The very popular 595 shift register chip of the 74 series is used a lot by hobbyis because of its wide availability, good speed and simplicity. Just plug it on an arduino like shown in the tutorials and youi have 8 more outputs, put two and you have 16 more outputs ! (up to a lot of them actually, with only three pins !)
no odor finely drilled tough including power pad. Clean hole
High quality protoboard gives you 6x8cm of building space for through-hole components.
The Wemos D1 mini Pro is a mini wifi board based on ESP-8266EX
“An open-source firmware and development kit that helps you to prototype your IOT product within a few Lua script lines” Based on ESP8266 ESP12E wifi board, on-board USB-TTL support directly flashing from USB port, also on-board power circuits and all IOs setup.