The TB6612FNG motor driver can control up to two DC motors at a constant current of 1.2A (3.2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes - CW, CCW, short-brake, and stop.
This protoboard is double sided, meaning that you can easily put components on both sides. It is perfect for all your DIY projects, as with its 0.1" (2.54mm) pitch it fits nearly all the through hole components.
D-duino can be programed like Arduino. It has a display(0.96 inch OLED) so I call it D-duino. Also you can use LUA control this board like NodeMCU. You can understand this is NodeMCU+OLED. I think the 0.96″ OLED will be very helpful for makers to develop IOT.
This is a splittable 40 pin jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Latest Arduino sensor Shield V5.0 reserves advantages of Arduino Sensor V4.0,such as lamination design, PCB immersion god process, and main board extend all the figures and analog interfaces of Arduino controller. I2C interface, 32 steering engineer controller interface, Bluetooth module communication interface ,SD card module communication interface,...