Horizontal Potentiometer (6mm shaft / 35mm length, 100k, Linear)

IHMPOTHORLI100K
€1.83

A simple 100k ohm vertical linear potentiometer for all your projects.

You might also like

HackSpark
  1. All our products are shipped from France.
  2. A doubt about a purchase ? Return your items and get money back.
  3. We carefully choose and test the products we sell.

Features:

  • Total resistance: 100kΩ
  • Rotation angle: 280
  • Type: Linear
  • Max V: 250VDC
  • Actuator Length: 35mm
  • Center detent: no
11 Items
New product
No reviews

Customers who bought this product also bought:

Out of stock
ESP32

M5Stack Basic Kit (ESP32 dev module, Wifi,...

MCBM5STKIT
€30.00
This is one of the greatest kits available for the ESP32. Gives you a nice polished enclosure, a back module with connectors and a small battery, an usb type c cable and jumper wires. If you need to have a nice one shot product or a polished prototype using wifi and/or bluetooth, this is the kit you need. With the protoboards (not included) and upcoming...
View
2
Available
Electronics

5x7 Protoboard (double sided)

PCB00004
€1.67
This protoboard is double sided, meaning that you can easily put components on both sides. It is perfect for all your DIY projects, as with its 0.1" (2.54mm) pitch it fits nearly all the through hole components.
2
Available
Electronics

2W Solar Panel 110x136

ENESES2W
€10.00
This solar panel is made of single-crystal material that performs high solar energy transformation efficiency at 17%. It has a fine resin surface and sturdy back suitable for outdoor environments. A 2mm JST connecter is attached to the penal, which makes it perfect to team up with most of our can-use-solar-power-supply boards, like Seeeduino...
Available
Power and Energy

Lithium battery CR 1220

BATLITCR1220
€1.25
Pile: lithium; 3V; CR1220; Nb.de piles:5; Ø12x2mm; 35mAh
2
Available
Arduino

CNC Shield for Arduino (GRBL Arduino Compatible)

ASHCNCGRBLKIT
€6.67
The Arduino CNC Shield makes it easy to get your CNC projects up and running in a few hours. It uses opensource firmware on Arduino to control 4 stepper motors using 4x A4988 or DRV8825 with this shield and an Arduino you can build all kinds of robotics or CNC projects including CNC routers, laser cutters and even pick&place machines. This is the KIT...
Product added to wishlist
Product added to compare.