Your cartThere are no more items in your cart
Vertical Potentiometer 50k (9mm shaft / 11mm length, 50k, linear)
A simple 50k ohm vertical linear potentiometer for all your projects.
- Total resistance: 50kΩ
- Rotation angle: 280
- Type: Linear
- Max V: 20VDC
- Actuator Length: 11mm
- Center detent: no
Customers who bought this product also bought:
Standard size breadboard that is perfect for prototypes. It does even have power rails on the sides to allow for more than one power level. The one you will get is white and not transparent as in the picture.Breadboard
This is a splittable 40 pin dual male jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
This is a basic, 4-digit 7-segment display - red in color. It's common anode. The display features one decimal point per digit, and individually controllable apostrophe points. The LEDs have a forward voltage of 2.1VDC and a max forward current of 20mA. The hardware interface is twelve (two rows of six) through-hole pins.
This is a dedicated antenna which is especially designed for a wireless communication system (433MHz). It has good VSWR, small size, ingenious structure, easy installation, stable performance, with good anti-vibration and anti-aging ability.
High power mosfet to switch all your devices/leds/motors easily. This is the P-type, meaning you have to put it between the load and the ground.
Here is a design for a full-featured motor shield that will be able to power many simple to medium-complexity projects.
Tired of finding a design where you need a specific capacitor value ? This 120 capacitors starter kit is perfect to fill your capacitor drawers to begin with electronics at a killer price !
A single pack of 100 resistors of the same value, useful for big projects or for very common resistor values.
Nokia 5110 LCD is a low-cost 84*48 pixels graphic LCD. It uses the PCD8544 controller. The PCD8544 interfaces to microcontrollers through a serial bus interface (5-wires).
This cheap 16x2 characters lcd is perfect for use with an arduino or any other microcontroller to display data quickly. It is compatible with the Hitachi HD44780 lcd driver.