Your cartThere are no more items in your cart
Horizontal Potentiometer (9mm shaft / 15mm length, 50k, linear)
A simple 50k ohm horizontal linear potentiometer for all your projects.
- Total resistance: 50kΩ
- Rotation angle: 280
- Type: Linear
- Max V: 20VDC
- Actuator Length: 15mm
- Center detent: no
- Fréquence Radio
- Display Type
- Tension en entrée
- Zone de stockage
- Résolution d'affichage
- Mémoire RAM (vive)
- Etage de rangement
- Compatibilité avec les cartes
- Watts (sortie)
- Coeurs CPU
- Google Product Type
- Vitesse d'horloge
- Type de CPU
- Couleurs d'affichage
- Mémoire Flash (programme)
- Colonne de rangement
- Watts (entrée)
- Prix d'achat
- Famille de micro-controlleur
Customers who bought this product also bought:
The A4988 stepper motor driver carrier is a breakout board for Allegro’s A4988 microstepping bipolar stepper motor driver. The driver features adjustable current limiting, overcurrent and overtemperature protection, and five different microstep resolutions (down to 1/16-step). It operates from 8 – 35 V and can deliver up to approximately 1 A per phase...
SG90 9g servo is a high quality,low-cost servo for all your mechatronic needs.
The FunDuino Uno is a microcontroller board based on the Arduino UNO. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer...
This is a splittable 40 pin dual female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
This is a standard solderless breadboard - three binding posts, 4 power buses, black aluminum plate backing. It works with a wide variety of wire gauges (29-20 AWG). With a total of 1660 tie in points, all pins are spaced by a standard 0.1".
This P6100 probe can be used with general purpose oscilloscope having a 1MΩ input impedance and bandwidth up to 100MHZ. It is also compatible with DSO Nano if you have a TRS 3.5mm to BNC converter and with the DSO Quad if you have a BNC to MCS converter.
This is a simple tactile switch of 6x6mm.
Whenever you want to use a breadboard for prototyping you need wires and preparing wires is long. Those wires are already prepared and come in four different sizes in the pack. Unlike other wires you can find on the web, those are reinforced, with a molded barrel and a real connector. No more open circuits or bad connections in your circuits with those...
Design a clock, timer or counter into your next project using this pretty 4-digit seven-segment display. These bright crisp displays are good for adding numeric output. Besides the four 7-segments, there are decimal points on each digit and an extra wire for colon-dots in the center (good for time-based projects) and a top right hand dot which could be...
Another Mini TRS 3.5mm to BNC probe converter, You can directly convert any other BNC probe from other Oscilloscope to a DSO nano compatible probe.