Your cart
There are no more items in your cart
ESP-WROOM-32 0.96" ESP-32 OLED WIFI-BT Dual-mode 2.4GHz
WIRELE32WROOLED
€14.58
€16.58
-€2.00
ESP-WROOM-32 ESP32 ESP-32 0.96" OLED Display WIFI-BT for Arduino AP STA
-
Description:ESP32 has integrated antenna and RF Barron, power amplifier, low noise amplifier, filter and supply Management module. The entire solution is the smallest PCB area. The board is 2.4 GHz dual-mode Wi-Fi and Bluetooth low power technology, with a wide range of safe, reliable and scalable applications for the TSMC 40nm chips, power and best RF features.Features:high-performance price ratio, small size, easy embedding to other products powerful, with the support of the LwIP protocol, support three modes: using AP, STA and AP and STA LUA program support, easy to develop
6 Items
New product
No reviews
Customers who bought this product also bought:
Dev. Tools
OLED Shield - (Wemos D1 Mini)
OLEWEM066
€7.45
€12.25
OLED Shield is a I2C screen 0.66" across.
Electronics
Usb to Micro USB Cable (1.0M)
CABMICUSB18M
€4.00
1.5 Meter micro-usb cable. Perfect to connect to your phone, dev board or to power a raspberry pi.
Electronics
Vertical Potentiometer 10k (9mm shaft / 11mm...
IHMPOTVERLI10K
€1.17
A simple 2k ohm vertical linear potentiometer for all your projects.
Electronics
Lithium Polymer Battery - 2500mAh 3.7V
ENEBATLP475085
€15.00
This is a light weight, high energy density polymer lithium battery. It outputs a nominal 3.7v at 2500mAh, including built-in protection against over voltage, over current, and minimum voltage. It comes terminated with a standard 2-pin JST connector-2.54 mm spacing between pins. Please do not attempt to charge these with anything but a specialized Lithium...
Electronics
Flow switch (MR-W1-P)
SWISESMRW1P
€15.00
This sensor works as a switch, lets the current flow while water passes though.
Electronics
GY-BME280 High Precision Atmospheric Pressure,...
SENGYBME280
€10.08
GY-BME280 is a Breakout Board featuring a Bosch Sensortec BME280 Temperature, Humidity & Pressure Sensor. The board has selectable I2C address jumper (solder link GS2), I2C pull-up resistors, 7 pin header 2.54mm, and two mounting holes 3.5mm. Default setting of the board; single power rail Vdd=Vdd_IO (solder link GS1), pull-ups resistors (R2, R3) 10k,...
Prototyping
Medium (Basic) Breadboard ( White, 16.5*5.5 cm...
PCB00008
€5.00
Standard size breadboard that is perfect for prototypes. It does even have power rails on the sides to allow for more than one power level. The one you will get is white and not transparent as in the picture.Breadboard
Electronics
Joystick ALPS SKQU 4 direction w/ Switch
IHMALPSSKQU
€3.00
Just ass a joystick to any project with the ALPSA SKQU. It's a handy button with a 4 direction joystick in an easy to mount small package.