A simple infrared shield including transmitting and receiving function, so the IR signal can be receive, store and replay, so this work flow is a recording. Now you can replace all the remote controller of your domestic appliance by arduino!
Two programmer LED and two programmer buttons, one extra ‘SEND’ LED serial connects to the Infrared transmitter, so whenever the transmitter is working you can see this LED blink too. See all the pin definition on wiki page.
Supported by arduino library IRremote.
Note: all the IR signal can be read but not all can be “recognized” by the code (for example NEC code), some signal will only be read and identified as “raw” data, but may not re-presentable, this is code issue, please try it yourself.
Arduino Sensor Shield V4.0 let us to build electronics projects just as easy as piling bricks. It can connect to various modules like sensors, servos, relays, buttons, potentiometers. Just plug & play.
Each functional module has buckled port with VCC, GND and Output, which has corresponding port on the Sensor Shield, connected with a plain 2.54mm...
This protoboard is double sided, meaning that you can easily put components on both sides. It is perfect for all your DIY projects, as with its 0.1" (2.54mm) pitch it fits nearly all the through hole components.
The RTC module is specifically designed for Raspberry Pi. It communicated with Raspberry Pi through I2C bus. There is a Maxim DS1307 and CR1220 button cell on the board to keep the real time for a long time after the Raspberry Pi has its power down. Set a serial port, TTL convenient way online debugging.
Intégration complète sur une seule carte: Mega R3 ATmega2560 et WiFi ESP8266 avec mémoire 32 mo (mégaoctets)
Tous les modules peuvent fonctionner ensemble ou chacun séparément. Et chacun a ses propres têtes de brochage
La solution pratique pour le développement de nouveaux projets nécessitant Uno et WiFi
Via USB, vous pouvez mettre à...
The Screw Shield extends all pins of the Arduino out to 3.5mm pitch screw terminals. It also has a lot of the utility provided by Arduino Protoshield, including: a large prototyping space of both connected and unconnected 0.1" spaced through-holes, a couple 5V and GND busses, a reset button, and a 5mm green LED.
This is a light weight, high energy density polymer lithium battery. It outputs a nominal 3.7v at 2500mAh, including built-in protection against over voltage, over current, and minimum voltage. It comes terminated with a standard 2-pin JST connector-2.54 mm spacing between pins. Please do not attempt to charge these with anything but a specialized Lithium...
Digital RGB LED Flexi-Strip is an intelligent light source consist s of WS2812B RGB LED with Integrated Driver Chip. The control circuit and RGB chip are integrated in a package of 5050 components.
This LED flexible strip is a full-color that external control for each lamp beads. It with high brightness, can achieve effects of full color running water,...