Servo head bracket two degrees bracket set (Without Servo) (Robotique)

ECRRKI00206K
Out-of-Stock
€5.83

kit that has all the mechanical fixtures .

You might also like

HackSpark
  1. All our products are shipped from France.
  2. A doubt about a purchase ? Return your items and get money back.
  3. We carefully choose and test the products we sell.
New product
No reviews

Customers who bought this product also bought:

2
Available
Electronics

DRV8825 stepper motor driver with heat sink...

MDRDRV8825
€6.25
This product is a carrier board or breakout board for TI’s DRV8825 stepper motor driver; we therefore recommend careful reading of the DRV8825 datasheet (1MB pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2.2 A output current per coil (see the Power Dissipation Considerations section below for...
2
  • Reduced price / -€3.50
Available
Dev. Tools

FunDuino UNO (ATMega 328P board compatible with...

MCBFUNUNO
€12.50 €16.00
The FunDuino Uno is a microcontroller board based on the Arduino UNO. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer...
2
Available
Electronics

male female splittable jumper wires (300mm, 40...

CONSEDJMP40PMF
€5.00
This is a splittable 40 pin male-female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
2
Available
Motorized

MG995 Servo 180 degree

MOTSERVOMG955180
€9.17
Great for truck, Boat, Racing Car, Helicopter and Airplane. mg995
Out of stock
ESP32

M5Stack Basic Kit (ESP32 dev module, Wifi,...

MCBM5STKIT
€30.00
This is one of the greatest kits available for the ESP32. Gives you a nice polished enclosure, a back module with connectors and a small battery, an usb type c cable and jumper wires. If you need to have a nice one shot product or a polished prototype using wifi and/or bluetooth, this is the kit you need. With the protoboards (not included) and upcoming...
View
2
Available
Home

CNC Shield for Arduino (GRBL Arduino Compatible)

ASHCNCGRBLKIT
€6.67
The Arduino CNC Shield makes it easy to get your CNC projects up and running in a few hours. It uses opensource firmware on Arduino to control 4 stepper motors using 4x A4988 or DRV8825 with this shield and an Arduino you can build all kinds of robotics or CNC projects including CNC routers, laser cutters and even pick&place machines. This is the KIT...
Product added to wishlist
Product added to compare.