Your cartIl n'y a plus d'articles dans votre panier
Servo head bracket two degrees bracket set (Without Servo) (Robotique)
Nice biped kit that has all the mechanical fixtures you need to create your own biped robots.
Les clients qui ont acheté ce produit ont également acheté...
This is a simple male header, very useful for a lot of things, including to plug boards like the arduino on your protoboards.
This is one of the greatest kits available for the ESP32. Gives you a nice polished enclosure, a back module with connectors and a small battery, an usb type c cable and jumper wires. If you need to have a nice one shot product or a polished prototype using wifi and/or bluetooth, this is the kit you need. With the protoboards (not included) and upcoming...
This product is a carrier board or breakout board for TI’s DRV8825 stepper motor driver; we therefore recommend careful reading of the DRV8825 datasheet (1MB pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2.2 A output current per coil (see the Power Dissipation Considerations section below for...
The A4988 stepper motor driver carrier is a breakout board for Allegro’s A4988 microstepping bipolar stepper motor driver. The driver features adjustable current limiting, overcurrent and overtemperature protection, and five different microstep resolutions (down to 1/16-step). It operates from 8 – 35 V and can deliver up to approximately 1 A per phase...
Outils de dev.
12,50 € 16,00 €
The FunDuino Uno is a microcontroller board based on the Arduino UNO. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer...
SUPPORT EN L ALUMINIU ESTAMPILLÉ POUR NEMA 17
Bases de l'électronique
Dimensions: 18 x 35mm
Boîtiers pour prototypes
No screws, no glue - just add your Raspberry Pi Camera !
This is a splittable 40 pin male-female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
The Arduino CNC Shield makes it easy to get your CNC projects up and running in a few hours. It uses opensource firmware on Arduino to control 4 stepper motors using 4x A4988 or DRV8825 with this shield and an Arduino you can build all kinds of robotics or CNC projects including CNC routers, laser cutters and even pick&place machines. This is the KIT...