Your cartThere are no more items in your cart
Arduino IR Infrared shield
A simple infrared shield including transmitting and receiving function.
- A simple infrared shield including transmitting and receiving function, so the IR signal can be receive, store and replay, so this work flow is a recording. Now you can replace all the remote controller of your domestic appliance by arduino!
- Two programmer LED and two programmer buttons, one extra ‘SEND’ LED serial connects to the Infrared transmitter, so whenever the transmitter is working you can see this LED blink too. See all the pin definition on wiki page.
- Supported by arduino library IRremote.
- Note: all the IR signal can be read but not all can be “recognized” by the code (for example NEC code), some signal will only be read and identified as “raw” data, but may not re-presentable, this is code issue, please try it yourself.
- IRremote library
- Résolution d'affichage
- Google Product Type
- Colonne de rangement
- Type de composant
- Couleurs d'affichage
- Zone de stockage
- Etage de rangement
- Display Type
Customers who bought this product also bought:
Arduino Sensor Shield V4.0 let us to build electronics projects just as easy as piling bricks. It can connect to various modules like sensors, servos, relays, buttons, potentiometers. Just plug & play. Each functional module has buckled port with VCC, GND and Output, which has corresponding port on the Sensor Shield, connected with a plain 2.54mm...
The Screw Shield extends all pins of the Arduino out to 3.5mm pitch screw terminals. It also has a lot of the utility provided by Arduino Protoshield, including: a large prototyping space of both connected and unconnected 0.1" spaced through-holes, a couple 5V and GND busses, a reset button, and a 5mm green LED.
Small but powerfull 360-degrees continuous rotation servo. (38g, 5.5kg/cm, 4.8v-6v)
Foca is a FT232RL breakout. The FT232RL is a USB to serial UART interface with optional clock generator output. It’s the essential tools for establishing communication between PC and mostly MCU. Especially, it’s the optimum tool for basic boards without without USB interface, like arduino pro, colorduino, etc. The good point is that it also supports the...
This protoboard is double sided, meaning that you can easily put components on both sides. It is perfect for all your DIY projects, as with its 0.1" (2.54mm) pitch it fits nearly all the through hole components.
This is the official current Arduino board, top quality, made in Italy and with a Zero Carbon Footprint!Arduino UNO Rev 3 ( R3 )The Arduino Uno is a microcontroller board based on the ATmega328 (datasheet). It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz crystal oscillator, a USB connection, a power...
The RTC module is specifically designed for Raspberry Pi. It communicated with Raspberry Pi through I2C bus. There is a Maxim DS1307 and CR1220 button cell on the board to keep the real time for a long time after the Raspberry Pi has its power down. Set a serial port, TTL convenient way online debugging.
The 433M RF link kit is consisted of transmitter and receiver, popular used for remote control. 433MHz frequency and ASK modulation.
This is a light weight, high energy density polymer lithium battery. It outputs a nominal 3.7v at 2500mAh, including built-in protection against over voltage, over current, and minimum voltage. It comes terminated with a standard 2-pin JST connector-2.54 mm spacing between pins. Please do not attempt to charge these with anything but a specialized Lithium...
This is a long male header, very useful for a lot of things, including to plug boards like the arduino on your protoboards.