Your cartThere are no more items in your cart
40P 250mm GPIO Ribbon Cable for Raspberry Pi
For moving parts between the motherboard, PCB board between the PCB and small electrical apparatus for data transmission.
- Interface: IDC40
Customers who bought this product also bought:
This is a 90 degree angle male header, very useful for a lot of things, including to plug boards like the arduino on your protoboards.
This is a simple tactile switch of 6x6mm.
Resistor Arrays 9PIN ISO. 330 OHM
Jack 3,5mm; Female; stereo, with grommet; straight; for cable
Wires and Connectors
4mm Banana Plug Black + Red
The RTC module is a member of Twig. It is based on the clock chip DS1307 which supports the I2C protocol.
This kit is used for one way wireless communication at a frequency of 433MHz and includes a transmitter module and a receiver module. The twig configuration of this kit allows for around 40 meters of transmitting distance indoors, or around 100 meters outside.
Brushless Outrunner Motor A2212/13 1000 KV, 47G, 12A Small size and light weight. 3mm hardened steel shaft, dual ball bearings. Includes collet type prop adapter and radial motor mount.
Standard size breadboard that is perfect for prototypes. It does even have power rails on the sides to allow for more than one power level. The one you will get is white and not transparent as in the picture.Breadboard
This Thumb Joystick is similar to the 'analog' joystick on PS2 (PlayStation 2) controllers. The X and Y axes are two ~10k potentiometers which control 2D movement by generating analog signals. The joystick also has a push button that could be used for special applications.