Breakout for Raspberry Pi A+/B+/2/3/4 to Breadboard (T-Cobbler Plus)

BRBRPIPLTCOB
€4.08

This is a T-Cobbler breakout kit used for extending the GPIO interface on Raspberry Pi B+,2  3 4 to breadboard. It helps you to make the connections between Raspberry Pi B+/2/3/4 breadboard become simple.

You might also like

HackSpark
  1. All our products are shipped from France.
  2. A doubt about a purchase ? Return your items and get money back.
  3. We carefully choose and test the products we sell.

For Raspberry Pi 3, 2, B+ and A+ only.

4 Items
New product
No reviews

Customers who bought this product also bought:

Available
Electronics

Raspberry Pi Camera 1.3

SENRPICAM
€16.58
The Raspberry Pi Camera Module is a custom designed add-on for Raspberry Pi. It attaches to Raspberry Pi by way of one of the two small sockets on the board upper surface. This interface uses the dedicated CSI interface, which was designed especially for interfacing to cameras. The CSI bus is capable of extremely high data rates, and it exclusively...
2
Available
Electronics

4x6 Protoboard

PCBPROTO4x6
€1.50
no odor finely drilled tough including power pad. Clean hole
2
Available
Electronic basics

Small Breadboard (8x6, "Half-size")

PCB00002
€4.58
Half size breadboard that is perfect for small prototypes. It does even have power rails on the sides to allow for more than one power level.
2
Out of stock
Electronics

Grove - GPS

SENSEDGPSGRV
€29.26
This Grove - GPS module is a cost-efficient and field-programmable gadget armed with a SIM28 (U-blox 6 is old version) and serial communication configuration. It features 22 tracking / 66 acquisition channel GPS receiver. The sensitivity of tracking and acquisition both reach up to -160dBm, making it a great choice for personal navigation projects and...
View
2
Available
Electronics

GY-BME280 High Precision Atmospheric Pressure,...

SENGYBME280
€10.08
GY-BME280 is a Breakout Board featuring a Bosch Sensortec BME280 Temperature, Humidity & Pressure Sensor. The board has selectable I2C address jumper (solder link GS2), I2C pull-up resistors, 7 pin header 2.54mm, and two mounting holes 3.5mm. Default setting of the board; single power rail Vdd=Vdd_IO (solder link GS1), pull-ups resistors (R2, R3) 10k,...
2
Available
Electronics

5x7 Protoboard (double sided)

PCB00004
€1.67
This protoboard is double sided, meaning that you can easily put components on both sides. It is perfect for all your DIY projects, as with its 0.1" (2.54mm) pitch it fits nearly all the through hole components.
2
Available
Electronics

DHT-11 Temperature & Humidity Sensor

SENDHT11
€2.50
This sensor provides temperature and humidity data with a quite good sensibility in a serial format thanks to its built-in micro-controller.
Product added to wishlist
Product added to compare.