Your cartThere are no more items in your cart
Dual female splittable jumper wires (100mm, 40 pins) (cable)Seeed Studio
This is a splittable 40 pin dual female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Cables of 100mm, 2 female pins, 40 wires assembled as one splittable cable.
Customers who bought this product also bought:
For moving parts between the motherboard, PCB board between the PCB and small electrical apparatus for data transmission.
A prototype AA battery case, it has on/off switch on the case, and it can be fully closed by cap and further screw it to close, so it’s very well protected.
8cm x 12cm protoboard with 2.54mm spacing
Raspberry Pi 3 Model B+ 1GB RAM The Raspberry Pi 3 Model B+ is the latest product in the Raspberry Pi3 range, boasting a 64-Bit quad core processor running at 1.4GHz, dual band 2.4GHz / 5.0GHz wireless, Bluetooth 4.2/BLE, faster Ethernet and PoE capability via a separate PoE HAT. The dual band wireless comes with modular compliance certification...
This is a 16-Channel Relay module, It can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM and MSP430.
The Raspberry Pi Camera Module is a custom designed add-on for Raspberry Pi. It attaches to Raspberry Pi by way of one of the two small sockets on the board upper surface. This interface uses the dedicated CSI interface, which was designed especially for interfacing to cameras. The CSI bus is capable of extremely high data rates, and it exclusively...
Standard size breadboard that is perfect for prototypes. It does even have power rails on the sides to allow for more than one power level. The one you will get is white and not transparent as in the picture.Breadboard
This is a 5V 1-Channel Relay module, It can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM and MSP430.
Chainable RGB LED Twig is based on P9813 chip which is a full-color light source LED driver chip, can provide constant current drive and modulated output of 256 gray. Transmission by wire (DATA and CLK), built-in recycling, can enhance the transmission distance.