Your cartThere are no more items in your cart
Dual male splittable jumper wires (300mm, 40 pins) (cable)Seeed Studio
This is a splittable 40 pin dual male jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Cables of 300mm, Dual male pins, 40 wires assembled as one splittable cable.
Customers who bought this product also bought:
This is an host and slave bluetooth module based on HC-05 with buillt-in voltage regulator.
If you are in need of such a 4.0 BLE Bluetooth module, MCU can be set up,also can controlled by a remote Bluetooth device for setting,can transfer data, and can remotely control 10 PIO pins,so,the best choice is HM-10 bluetooth module. can replace HC-05, HC-06, HC-07 etc.
A simple rotary encoder for all your projects. It's like a potentiometer, but without end. It sends pulse to your microcontroller to let you know in which direction it turned. This version also has a button.
This adapters allows you to use a VGA monitor on any board with HDMI output. It has been tested on resolutions up to 1920x1080.
The Screw Shield extends all pins of the Arduino out to 3.5mm pitch screw terminals. It also has a lot of the utility provided by Arduino Protoshield, including: a large prototyping space of both connected and unconnected 0.1" spaced through-holes, a couple 5V and GND busses, a reset button, and a 5mm green LED.
HDMI 1.4, High Speed + Ethernet, Gold platted.
You can simply plug this USB Wifi dongle into the USB port of your Dev Board and you're ready to connect to a nearby wireless network with extra power thanks to its antenna.
Nice SPDT rocker switch to add an on/off button to your projects.