Your cartThere are no more items in your cart
Power MOSFET (N-Type, IRFZ24NPBF, 55v-17A max.)
High power mosfet to switch all your devices/leds/motors easily. This is the N-type, meaning you have to put it between the load and the ground.
|unipolar, N-MOSFET, HEXFET|
Customers who bought this product also bought:
8cm x 12cm protoboard with 2.54mm spacing
Ultra light and small yet powerful servo, ideal for small robotics, boats, planes or any small item, you get the idea.
Quadruple Half-H Drivers L293 DIP16
High quality protoboard gives you 9x15cm of building space for through-hole components with 2.54mm spaced holes.
News ESP8266 improve the peripheral circuit, enhance the impedance matching, signal output is better, both stability and anti-interference ability, have been greatly improved. ESP8266 is a ultra-low power UART-WiFi module. It has excellent dimensions and ULP technology compared to other similar modules. The module is special design for monile devices and...
This is a T-Cobbler breakout kit used for extending the GPIO interface on Raspberry Pi B+,2 or 3 to breadboard. It helps you to make the connections between Raspberry Pi B+/2/3 breadboard become simple.
ESP32-DevKitC is a low-footprint, minimal system development board which is powered by our latest ESP-WROOM-32 module and can be easily adjusted to a breadboard.
In the pursuit for small form factor, flexibility and functionality comes Seeeduino Mega – derived from Arduino Mega it harnesses the power of ATmega1280 to spice up your project building experience. ATmega 1280 @ 16MHz Selectable 5V/3.3V operation 70 Digital IO 16 Analog inputs 14 PWM outputs 4 Hardware serial ports Compatible with most Arduino Shields...
Using brand new double MOS AOD4184A parallel active output, lower resistance, more current, strong power at room temperature, 15A, 400W, to meet the most use of the equipment; Wide voltage, the perfect support for PWM; Easy control of power equipment.
It's a small USB to TTL serial tool, using the PL2303 chip. You can use it to connect some serial device to your PC via USB port, an avr, an msp430 or an stm32 for example. It's very cheap compared to the ft232 alternative and works very well, up to more than 1mbit/s.