Your cartThere are no more items in your cart
Dual female splittable jumper wires (300mm, 40 pins)Seeed Studio
This is a splittable 40 pin dual female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Cables of 300mm, 2 female pins, 40 wires assembled as one splittable cable.
Customers who bought this product also bought:
no odor finely drilled tough including power pad. Clean hole
This a well designed, Arduino compatible mobile robot development platform,you can build it and program it easily with tons of published free codes. Compare with the last mobile platform, this one has a light body with mounting holes, you can add Variety of sensors to make it more interesting.
The Arduino Yún is a microcontroller board based on the ATmega32u4 (datasheet) and the Atheros AR9331. The Atheros processor supports a Linux distribution based on OpenWRT named Linino. The board has built-in Ethernet and WiFi support, a USB-A port, micro-SD card slot, 20 digital input/output pins (of which 7 can be used as PWM outputs and 12 as analog...
The very popular 595 shift register chip of the 74 series is used a lot by hobbyis because of its wide availability, good speed and simplicity. Just plug it on an arduino like shown in the tutorials and youi have 8 more outputs, put two and you have 16 more outputs ! (up to a lot of them actually, with only three pins !)
This is a framed graphical LCD 64x128 with yellow or blue black-light . This unit is a very clear STN type LCD with a simple command interface.
This is a splittable 40 pin male-female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
The D1 is an Arduino Uno-like wifi board based on ESP-8266EX. 11 digital input/output pins 1 analog input(3.3V max input) a Micro USB connection a power jack, 9-24V power input. Compatible with Arduino
Simple 5mm yellow led with 20mcd power.
Nice cable with a smaller section, ideal for a lot of electronic board to board wiring.Wire-wrapping
This is a T-Cobbler breakout kit used for extending the GPIO interface on Raspberry Pi to breadboard. It helps you to make the connections between Raspberry Pi and breadboard become simple.