- Motorized
- Tools
-
Dev. Tools
-
Electronics
- Power and Energy
- Wires and Connectors
- Grove
- USB Peripherals
- Motors and Servos
- LEDs & Lights
- Assembly kits
- Domotic
- Break-out Boards
- Network
- Electronic basics
- PCBs
- Sound
- Integrated Circuits (ICs, Chips)
- Wireless Connectivity
- Sensors
- Human Interface
- CMS / SMD
- Others
- Prototyping
HC-06 Bluetooth V2.0 breakout board (Host and Slave, 3.6-6V)
€10.50
Tax included
Master/Slave Bluetooth serial module based on the HC-06 chip, featuring an integrated regulator for 3.6 to 6 V power supply.
It enables simple UART wireless communication via Bluetooth V2.0 + EDR, with a default baud rate of 9600 and a typical range of approximately 10 meters.
The HC-06 is a Bluetooth V2.0 + EDR adapter module designed for serial wireless communication between microcontrollers and host devices. This breakout board features an integrated voltage regulator, allowing direct power supply via a 3.6 to 6 V range while maintaining a 3.3 V logic level.
Specifications
- Bluetooth Version: V2.0 + EDR with built-in antenna.
- Supply Voltage: 3.6 V to 6 V (integrated regulator).
- Logic Level: Native 3.3 V.
- Default Baud Rate: 9600, 8 bits, No parity, 1 stop bit (8N1).
- Typical Range: Up to 10 meters (33 feet) in open space.
- Operation Mode: Slave mode by default (configurable to master via AT commands).
This module is suitable for adding simple Bluetooth connectivity to your Arduino, ESP32, or any UART-enabled system. The main connections include VCC (power), GND (ground), TX (serial transmission), and RX (serial reception).
WIRBTHC06CAB
6 Items
New
You might also like
Master/Slave Bluetooth serial module based on the HC-06 chip, featuring an integrated regulator for 3.6 to 6 V power supply.
It enables simple UART wireless communication via Bluetooth V2.0 + EDR, with a default baud rate of 9600 and a typical range of approximately 10 meters.