Your cartThere are no more items in your cart
MCP23017 16-bit I/O E/SL, i2c input/output expander)Microchip
- 16-bit remote bidirectional I/O port
- I/O pins default to input
- • High-speed I2C™ interface (MCP23017)
- 100 kHz
- 400 kHz
- Three hardware address pins to allow up to eight devices on the bus
- Operating Voltage: 1.8V to 5.5V
Customers who bought this product also bought:
Very good open source programmer for AVR chips.
Photo-interrupter to sense when an object is close (if read as digital), and how close it is (if read as analog), in very near range.
This is a simple male header, very useful for a lot of things, including to plug boards like the arduino on your protoboards.
This is a splittable 40 pin dual female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
1.5 Meter micro-usb cable. Perfect to connect to your phone, dev board or to power a raspberry pi.
The RS232 to TTL UART MAX3232 converter module is widely used in radio modifications,phone flash, XBOX360 flash, GPS, vehicle detection, DVD flash, hard disk repair set-top box upgrade. It can be used to program STC MCU, NXP MCU,Renesas MCU, STM32 MCU, N+-2EC MCU.
CI commutateur multiplexeur 8-Channel Analog
The WeMos D1 mini is minimal ESP8266 wifi board. The D1 mini is a mini wifi board based on ESP-8266EX. more: http://www.wemos.cc
This is a simple and pretty common Fast-Switching Rectifier Diode rated at 0.15A, a must for a lot of projects.