Your cartIl n'y a plus d'articles dans votre panier
MCP23017 16-bit I/O (E/SL, i2c input/output expander)Microchip
- 16-bit remote bidirectional I/O port
- I/O pins default to input
- • High-speed I2C™ interface (MCP23017)
- 100 kHz
- 400 kHz
- Three hardware address pins to allow up to eight devices on the bus
- Operating Voltage: 1.8V to 5.5V
Les clients qui ont acheté ce produit ont également acheté...
Outils de dev.
The WeMos D1 mini is minimal ESP8266 wifi board. The D1 mini is a mini wifi board based on ESP-8266EX. more: http://www.wemos.cc
17,00 € 24,17 €
Put on your sunglasses before using this matrix with 64 eye-blistering RGB LEDs adorn the panel for a blast of configurable color. Arranged in a 8x8 matrix, each pixel is individually addressable. Only one pin is required to control all the LEDs. You can cut a trace and use nearly any other pin if you need some customization.
This is a splittable 40 pin dual male jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Nice little red matrix with easy-to-use backpack included
14,00 € 23,00 €
Digital RGB LED Flexi-Strip is an intelligent light source consist s of WS2812B RGB LED with Integrated Driver Chip. The control circuit and RGB chip are integrated in a package of 5050 components. This LED flexible strip is a full-color that external control for each lamp beads. It with high brightness, can achieve effects of full color running water,...
6,00 € 9,11 €
Nokia 5110 LCD is a low-cost 84*48 pixels graphic LCD. It uses the PCD8544 controller. The PCD8544 interfaces to microcontrollers through a serial bus interface (5-wires).
Transistor bipolaire 2N3906, PNP
This very tiny module (the size of the micro sd card reader) reads voice and music from the sd card, as needed from your micro-controller.
Outils de dev.
The high-performance, low-power Atmel 8-bit AVR RISC-based microcontroller combines 4KB ISP flash memory, 256-Byte EEPROM, 256B SRAM, 6 general purpose I/O lines, 32 general purpose working registers, one 8-bit timer/counter with compare modes, one 8-bit high speed timer/counter, USI, internal and external Interrupts, 4-channel 10-bit A/D converter,...
This 3 Axis Compass boad has a very good sensibility and features all the needed components to use the excellent HMC5883L chip