Your cartThere are no more items in your cart
16x2 Characters LCD (White on Blue) (screen) 1602 A
€4.00 €7.92 -€3.92
This cheap 16x2 characters lcd is perfect for use with an arduino or any other microcontroller to display data quickly. It is compatible with the Hitachi HD44780 lcd driver.
For more information, you can find a full tutorial on how to use those with an arduino there : http://arduino.cc/en/Tutorial/LiquidCrystal
Customers who bought this product also bought:
The Arduino ADK is a microcontroller board based on the ATmega2560 (datasheet). It has a USB host interface to connect with Android based phones, based on the MAX3421e IC. It has 54 digital input/output pins (of which 14 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power...
This is a splittable 40 pin dual female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Simple step-down module to use an higher voltage as a sorce for a circuit needing a lower one.
Brand new and high quality. SD Card module can make your SD application more easier and simple.
Design a clock, timer or counter into your next project using this pretty 4-digit seven-segment display. These bright crisp displays are good for adding numeric output. Besides the four 7-segments, there are decimal points on each digit and an extra wire for colon-dots in the center (good for time-based projects) and a top right hand dot which could be...
This product is a carrier board or breakout board for TI’s DRV8825 stepper motor driver; we therefore recommend careful reading of the DRV8825 datasheet (1MB pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2.2 A output current per coil (see the Power Dissipation Considerations section below for...
Main Boards and Compatible
Very nice miniature dev board for all your miniature usb needs :-).
Need a clean energy source for your project? Check out this compact, high quality, high output endurable solar panel. This solar panel mates directly with many of our development boards and has a high efficiency. Unit has a clear epoxy coating with hard-board backing, provides an efficient and waterproof surface for the panel application on out-door...
This is a splittable 40 pin jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
This great little display boasting a 176X220 resolution has a wide support for all your MCU and little ARM/Linux-based boards. It will work on Arduino, STM32, Raspberry Pi and others.Oh, did I mention it also has an SD card slot ? Making it maybe one of the best value display we can have to offer.