Your cartThere are no more items in your cart
Battery Level Display
This is battery level display module based on battery style digital tube LED. The 5 - segment LED inside is red light and the frame is green light. There is driver chip TM1651 onboard, so the control interface is simple, just two signal lines and VCC / GND. It can be used to display the battery power.
- Type de composant
- Mémoire Flash (programme)
- Display Type
- Zone de stockage
- Résolution d'affichage
- Etage de rangement
- Compatibilité avec les cartes
- Prix d'achat
- Tension en entrée
- Google Product Type
- Couleurs d'affichage
- Colonne de rangement
- Adresse de la page produit fabricant
Customers who bought this product also bought:
This 3 Axis Compass boad has a very good sensibility and features all the needed components to use the excellent HMC5883L chip
2.5mm Pull - Push Type Open Frame Solenoid Electromagnet DC 3-12V 0.3A
This is simple and small portable water level/water droplet identification, detection sensor water that have high cost performance. Complete water yield and analog conversion, the output value apply to your custom function. It is low power consumption and high sensitivity. It can make better performance with Arduino 328 controller and sensor relay shield....
Simply the interface of 1602 to IIC, save more IOs, with this board you only need two IOs. This board is also supporting 2004A which is also available in our store.
This is a splittable 40 pin jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
This is a standard solderless breadboard - three binding posts, 4 power buses, black aluminum plate backing. It works with a wide variety of wire gauges (29-20 AWG). With a total of 1660 tie in points, all pins are spaced by a standard 0.1".
0.1mm copper wire, ideal for your simple repair jobs (or to fix a mistake on a pcb :)). You can even use it to make your traces on a prototype pcb, soldering around it.
Simple heatsink kit for raspberry pi.