Your cartThere are no more items in your cart
8X16 LED Matrix for Raspberry PiElecrow
This product is a led-matrix dot-matrix-led-display modul, which compatible with Raspberry Pi B+, 2, 3 and B board. The insertion method for B+/2/3 is the same as that of B. The pin GPIO1 on Raspberry Pi B+ corresponds to GPIO1 on Raspberry Pi B.
- Support Raspberry Pi B/B+
- Driver chip : MAX7219
- Dot matrix type: 2 8x8 common cathode red dot matrix
- Module size:64.3x35.0x29mm
Customers who bought this product also bought:
Highly integrated module popularly used for entry detection, it complies with microcontroller or DC loads.
This is a 5V 8-Channel Relay module, It can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM and MSP430.
This is a digital temperature sensor, that is already calibrated. The measurement is done where the sensor is, no need for long insulated wire or complicated ADC design. This sensor is therefore also perfect for use with a Raspberry Pi, as it is not analogic, all the data is transmitted in digital One Wire protocol.
The A4988 stepper motor driver carrier is a breakout board for Allegro’s A4988 microstepping bipolar stepper motor driver. The driver features adjustable current limiting, overcurrent and overtemperature protection, and five different microstep resolutions (down to 1/16-step). It operates from 8 – 35 V and can deliver up to approximately 1 A per phase...
LEDs & Lights
Small 1W White led providing 80 to 90 lumens.
The FunDuino Uno is a microcontroller board based on the Arduino UNO. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer...
This is a splittable 40 pin male-female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
This is a basic, 4-digit 7-segment display - red in color. It's common anode. The display features one decimal point per digit, and individually controllable apostrophe points. The LEDs have a forward voltage of 2.1VDC and a max forward current of 20mA. The hardware interface is twelve (two rows of six) through-hole pins.
This is a splittable 40 pin dual female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
The Wireless Charging Module can be applied in electronic equipments in common use for close wireless charging or power supply. Consisted of a transmitter and insulation coil, it could serve as a replacement for the Wireless Power Supply with stable 5V output voltage and maximum 600mA output current. Its small size and insulation coil is more suitable for...