OLED 1.3-inch SH1315 based 128x64 pixel IIC I2C

OLETAO13
€11.00

SH1106 based 128x64 pixel OLED display running on the Arduino/ESP8266 platform

You might also like

HackSpark
  1. All our products are shipped from France.
  2. A doubt about a purchase ? Return your items and get money back.
  3. We carefully choose and test the products we sell.

SH1315 based 128x64 pixel OLED

11 Items
New product
No reviews

Customers who bought this product also bought:

2
Available
TFT LCD

LCD TFT Display Screen 2.4 240x320 (ILI9341)...

LCDGEN24ILI9341
€11.67
This great little display boasting a 240X320 resolution has a wide support for all your MCU and little ARM/Linux-based boards. It will work on Arduino, STM32, Raspberry Pi and others.Oh, did I mention it also has an SD card slot ? Making it maybe one of the best value display we can have to offer. 2.4" Serial TFT LCD 240X320 Display SPI (ILI9341)(Raspi...
Out of stock
Dev. Tools

NodeMCU AMICA R2 (LUA/Arduino/Python, ESP-12E,...

WIRNODMCUR2
€6.25
“An open-source firmware and development kit that helps you to prototype your IOT product within a few Lua script lines” Based on ESP8266 ESP12E wifi board, on-board USB-TTL support directly flashing from USB port, also on-board power circuits and all IOs setup.
View
2
Available
Electronics

DRV8825 stepper motor driver with heat sink...

MDRDRV8825
€6.25
This product is a carrier board or breakout board for TI’s DRV8825 stepper motor driver; we therefore recommend careful reading of the DRV8825 datasheet (1MB pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2.2 A output current per coil (see the Power Dissipation Considerations section below for...
Out of stock
Electronics

Grove - Universal 4 Pin Buckled 5cm (Cable)

GRVSED4PIN5
€0.67
The Universal 4 Pin Buckled Cable is made for the Grove System to connect all of the Twigs to the Stem - Basic Shield or to other Twig compatible boards for quick prototyping. As a lot of users ask for different length of cables, so we made the 5cm cables for different applications.
View
2
Out of stock
Electronics

Micro SD Card Reader Module - SPI interfaces...

MODJANMCSDCTF
€2.42
Support Micro SD card(<=2G), micro SDHC card(<=32G)Interface level: 5V  or 3.3VPowr supply: 4.5V to 5.5V , 3.3V voltage regulator circuit boardCurrency: 0.2-200mACommunication interface: SPIWith 4 holes for M2 screw. Easy to install
View
2
  • Reduced price / -€2.00
Available
Sensors

DHT-22 Temperature & Humidity Sensor

SENDHT22
€6.25 €8.25
The DHT-22 is a low cost humidity and temperature sensor with a single wire digital interface. The sensor is calibrated and doesn't require extra components so you can get right to measuring relative humidity and temperature.
Product added to wishlist
Product added to compare.