Your cartThere are no more items in your cart
WAGO Splice 5 terminal installation quick splice spring clamp 450V
|installation quick splice|
spring clip installation quick connector
Customers who bought this product also bought:
Simple 5mm orange led with 40mcd power. 1.6 - 2.6 V
This is a splittable 40 pin jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Chem-Wik® Rosin is especially designed for today’s heat sensitive electronic components. The lighter mass, pure copper braid construction allows for better thermal conductivity, even at low temperatures. Chem-Wik® Rosin responds as much as 50% faster than conventional desoldering braids. This design minimizes overheating and requires less “contact”...
Simple 5mm red led with 25mcd power.
“An open-source firmware and development kit that helps you to prototype your IOT product within a few Lua script lines” Based on ESP8266 ESP12E wifi board, on-board USB-TTL support directly flashing from USB port, also on-board power circuits and all IOs setup.
This is a simple female header, very useful for a lot of things, including to plug boards like the stm32f4 discovery or the arduino nano on your protoboards.
Z80 BOX X:89mm Y:119mm Z:38mm ABS BLACK CASE
Motors and Servos
This is a 5V 8-Channel Relay module, It can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM and MSP430.
Step up module DC-DC