• Reduced price

DSM501A dust sensor

SENDUSDSM501A
€14.00 €18.00 -€4.00

The dust sensor module DSM501A is low cost,compact size for a particle density sensor.

You might also like

HackSpark
  1. All our products are shipped from France.
  2. A doubt about a purchase ? Return your items and get money back.
  3. We carefully choose and test the products we sell.

Overview

The dust sensor module DSM501A is low cost,compact size for a particle density sensor. 

  • Quantitative particle measurement with the principle of particle counter.
  • FIne particle of which diameters are bigger than one micron could be detected with high sensitivity.
  • Inside heater realizes the self-air taking.
  • One control contact and two output contacts.

The DSM501A consists of:

  • Light Emitting Diode(LED) Lamp
  • Detector
  • Signal amplifier circuit
  • Output drive circuit 1
  • Output drive circuit 2
  • Heater

Features

  • PWM output
  • Compact size and lightweight
  • Easy installation
  • Single power supply

Application

  • Air cleaner or Air purifier
  • Air condition
  • Air quality monitor
  • Ventilator etc.

Download

datasheet

10 Items
New product
No reviews

Customers who bought this product also bought:

2
Available
Gaz / Volatile

Analog CO / Combustible Gas Sensor (MQ-9)

SENJANCOGAS
€4.50
MQ-9 The Analog CO/Combustible Gas Sensor(MQ9) module is useful for gas leakage detecting, it used the sensitive material SnO2, which with lower conductivity in clean air. It make detection by method of cycle high and low temperature, and detect CO when low temperature (heated by 1.5V). The sensors conductivity is more higher along with the gas...
2
  • Reduced price / -€4.00
Available
Electronics

Bread Board Power Supply Shield Micro USB...

ENEITEBREPOW
€3.50 €7.50
This is a power module for the standard bread boards (Small and Medium sized). It's concave design so will not wast your proto zone. It also supports both 5v and 3.3v (both can be enabled on each power rail). We think it is a must to have on your workbench, really.
2
Available
Electronics

RN-XV Wifly XBee (RN-171 XV, Wire antenna)

WIRRN171XV
€35.00
RN-XV XBEE The RN-171-XV is a 802.11 b/g solution especially designed for designers who want to migrate their existing 802.15.4 architecture to a more standard TCP/IP-based platform without redesigning their existing hardware. Based on a pseudo standard footprint often found in embedded applications, the Roving Networks’ RN-171-XV module provides Wi-Fi...
  • Reduced price / -€1.00
Available
Electronics

DS18B20+

ELCDS18B20
€3.00 €4.00
The DS18B20+ is a programmable resolution 1-wire digital thermometer in 3 pin TO-92 package. This digital thermometer provides 9bit to 12bit celsius temperature measurements and has an alarm function with non-volatile user programmable upper and lower trigger points. The DS18B20 communicates over a 1-wire bus that by definition requires only one data line...
2
Out of stock
Arduino

LilyPad Arduino USB (Arduino Compatible)

MCBARDLILYUSB
€19.17
The LilyPad Arduino USB is a microcontroller board based on the ATmega32u4 (datasheet). It has 9 digital input/output pins (of which 4 can be used as PWM outputs and 4 as analog inputs), an 8 MHz resonator, a micro USB connection, a JST connector for a 3.7V LiPo battery, and a reset button. It contains everything needed to support the microcontroller;...
View
Product added to wishlist
Product added to compare.