Your cart
There are no more items in your cart
18 pin double wipe integrated circuit pcb socket. (DIP18 )
ADASOCDIP18
€0.33
18 pin double wipe integrated circuit pcb socket. (DIP18 )
DIP | ||
18 | ||
7.62mm | ||
THT | ||
2.54mm | ||
platine de serrage double face |
97 Items
New product
No reviews
Customers who bought this product also bought:
Electronics
ULN2803A (DIP18 8-channels Darlington...
ELCULN2803A
€1.25
Easy to use Darlington Transistor Array for all your projects with diode protection and 8 channels.
Ethernet
W5100 Ethernet Shield for Arduino (Arduino...
ECRASW51001E
€13.75
The Arduino Ethernet Shield allows an Arduino board to connect to the internet. It is based on the Wiznet W5100 ethernet chip. The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield. The...
Dev. Tools
ATtiny85-20PU (microcontroller, 8-bit, 8kB...
ELCARDATTINY85
€2.00
The high-performance, low-power Atmel 8-bit AVR RISC-based microcontroller combines 8KB ISP flash memory, 512B EEPROM, 512-Byte SRAM, 6 general purpose I/O lines, 32 general purpose working registers, one 8-bit timer/counter with compare modes, one 8-bit high speed timer/counter, USI, internal and external Interrupts, 4-channel 10-bit A/D converter,...
Dev. Tools
PL2303 USB to UART (TTL) breakout
USBITEPL23035V
€4.08
It's a small USB to TTL serial tool, using the PL2303 chip.
You can use it to connect some serial device to your PC via USB port, an avr, an msp430 or an stm32 for example.
It's very cheap compared to the ft232 alternative and works very well, up to more than 1mbit/s.
Electronics
ULN2003 Stepper Motor Driver Board
MDRULN2003
€2.58
€4.58
ULN2003 Stepper Motor Driver Board is use the ULN2003 DARLINGTON ARRAYS to drive the 4-phase 5-wire stepper motors (5v-12v).
Dev. Tools
UNO R3 (Arduino Compatible ) CH340
MCB00003B
€9.58
The Uno is a microcontroller board based on the ATmega328 and compatible with the Arduino Uno R3. It has 14 digital I/O pins, 6 analog inputs, a 16MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or...
Main Boards and Compatible
Digispark Attiny Micro USB Development Board...
MCBDISPAMICROUSBB
€1.58
The Digispark is an Attiny based microcontroller development board similar to the Arduino line, only cheaper, smaller, and a bit less powerful. With a whole host of shields to extend its functionality and the ability to use the familiar Arduino IDE the Digispark is a great way to jump into electronics, or perfect for when an Arduino is too big or too...