Your cart
There are no more items in your cart
Pre-Connected three-Hole Prototype Board 5X10 Cm protoboard
PCB00005X3
€1.58
Pre-Connected three-Hole Prototype Board 5X10 Cm
2 Items
New product
No reviews
Customers who bought this product also bought:
Electronics
Infrared Kit - IR Receiver (HS0038) + IR LED...
IRELDRECTRANS
€0.79
hs0038 IR sensor tuned to 38KHz, perfect for receiving commands from a TV remote control. Runs at 5V (although it seems to be OK down to 3.3V)To use, connect pin 3 (all the way to the right) to 5V power, pin 2 (middle) to ground and listen on pin 1. It doesn’t do any decoding of the signal, just passes the ‘raw data’ along.
Arduino
LilyPad Arduino USB (Arduino Compatible)
MCBARDLILYUSB
€19.17
The LilyPad Arduino USB is a microcontroller board based on the ATmega32u4 (datasheet). It has 9 digital input/output pins (of which 4 can be used as PWM outputs and 4 as analog inputs), an 8 MHz resonator, a micro USB connection, a JST connector for a 3.7V LiPo battery, and a reset button. It contains everything needed to support the microcontroller;...
Tools
heat shrink sleeves (2mm L:1m 4:1 black Temp:...
THERJANRC022
€3.33
A nice set of heat shrinkable sleeves for all your cable assemblies.
Prototyping
Solderable Prototype Board 140 X 95mm...
BRBEDRSOLDGPCB
€3.00
Layout same as breadboard, and also same connection in the veritcal pin line.
Tools
Chem-Wik® Rosin Size 100 10-5L 5ft/1.5m 0.76
REMSOLCHWIK
€2.50
Chem-Wik® Rosin is especially designed for today’s heat sensitive electronic components. The lighter mass, pure copper braid construction allows for better thermal conductivity, even at low temperatures. Chem-Wik® Rosin responds as much as 50% faster than conventional desoldering braids. This design minimizes overheating and requires less “contact”...
Wire and Cable Tools
2 pin dual-female jumper wire - 300mm (10 PCs...
CABSED2PINFF
€4.00
€6.00
This is a splittable 2 pin dual female jumper wire, it is super flexible, With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
DC-DC Step-down
LD1117 / LM1117 - 3.3V LDO Voltage regulator...
ELCREG33V1117TO220
€1.50
This is a simple to use voltage régulator that outputs 3.3V at 1.3A