3W Solar Panel 145x145

Seeed Studio
ENESES3W
€14.30

This is a custom solar panel, which mates directly with many of our development boards and has a high efficiency at 16%. Unit has a clear epoxy coating with hard-board backing. Robust sealing for out door applications! solar

You might also like

HackSpark
  1. All our products are shipped from France.
  2. A doubt about a purchase ? Return your items and get money back.
  3. We carefully choose and test the products we sell.

This Solar panel comes with a  2mm JST connector.

Specification
  • PCB size : 145*145*3 mm
  • Monolithic : 10.93 * 156 mm
  • Efficiency : 15%
  • Voltage:5.5V;
  • Current:540mA
  • Power:3W
  • Type:156 Two line;
  • PCB Material : all Glass fiber
  • PCB requirements : positive
  • Quality requirements :
  • flatness less than 0.1mm
  • clean, does not allow to have the scratch
  • take off paint the phenomenon, such as a hole does not allow to have the deviation
  • Note : tolerance Positive and negative 0.1mm
  • Name: PET laminated (138*160)
  • Arrangement:1*11(series)NO spacing posted artical black;
18 Items
New product
No reviews

Customers who bought this product also bought:

Available
Electronics

5mm Green Led

LEDKIN5MMGRE
€0.10
Simple 5mm green led with 20mcd power.
2
Available
Home

DEW Sensor - HDS05

ECRSES05002S
€2.71
High-humidity sensor, usefull for weather appliances.
Available
Dev. Tools

MSP-EXP430F5529LP Launchpad

MCB00006
€17.50
TI's MSP430 Launchpad board is a perfect start in the MSP430 family with the value line chips (msp430g2xxx). With the fact that you an easily remove the chip to put in your own circuit or program nearly all the msp430f2xxx and msp430g5xxx chips, it makes for a great project factory at a very low price. Also, the pack comes with two micro-controllers (you...
2
Available
Dev. Tools

GPS Logger Shield Arduino , Ublox Neo-6M R2

ASHELEGPSSHIELD
€16.58
Arduino GPS shield is a GPS module breakout board for Arduino. It can make your Arduino as a GPS receiver with SD storage, it is easy to use for recording the position data into SD card by Arduino
2
Out of stock
Electronics

Dual male splittable jumper wires (100mm, 40...

CONSEDJMP40PMM10
€3.33
This is a splittable 40 pin dual male jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
View
2
Out of stock
Electronic basics

Combined 1660 Point Breadboard (2xMedium...

PCBFLY1660PT
€15.00
This is a standard solderless breadboard - three binding posts, 4 power buses, black aluminum plate backing. It works with a wide variety of wire gauges (29-20 AWG). With a total of 1660 tie in points, all pins are spaced by a standard 0.1".
View
  • Reduced price / -€2.00
Available
Electronics

ULN2003 Stepper Motor Driver Board

MDRULN2003
€2.58 €4.58
ULN2003 Stepper Motor Driver Board is use the ULN2003 DARLINGTON ARRAYS to drive the 4-phase 5-wire stepper motors (5v-12v).
2
Available
Electronics

IIC EEPROM and RTC Module DS1307 atmel832

SENSEDIICRTCEEPROM
€4.38
With compact design, the board can integrate the real-time clock module DS1307, EEPROM memory AT24C32 and digital temperature sensor DS18B20 (not supplied on the board) which are connected via I2C bus together on a 27mm*28mm*8.4mm board.
2
  • Reduced price / -€9.00
Available
Ethernet

W5100 Ethernet Shield for Arduino (Arduino...

ECRASW51001E
€8.50 €17.50
The Arduino Ethernet Shield allows an Arduino board to connect to the internet. It is based on the Wiznet W5100 ethernet chip. The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield. The...
Product added to wishlist
Product added to compare.