Your cartThere are no more items in your cart
LD1117 / LM1117 - 5V LDO Voltage regulator 1.3A TO220ST Microelectronics
This is a simple to use voltage régulator that outputs 5V at 1.3A
Customers who bought this product also bought:
Power and Energy
Stepdown 5V USB Output Converter DC 6...24V To 5V 3A Step Down Module Ideal to get a strong and stable 5v usb output from any source from 6 to 24V.
A prototype AA battery case, it has on/off switch on the case, and it can be fully closed by cap and further screw it to close, so it’s very well protected.
It is a good plastic box for Raspberry Pi, which can protect it with one of these snazzy plastic enclosures?. These cases protect the Raspberry Pi from things like rogue wires that might short it out while still allowing full access to the board! Simply snap the RPi into the bottom half of the enclosure, then snap the two sides together. The e
A simple 50k ohm horizontal linear potentiometer for all your projects.
This 45 in1 Precision multi-non-slip tough shaft ensures greater comfort and convenience. This screwdriver kit set is an ideal tool for repairing electronic workshops, watch, eyeglass, and hobby miniatures where fine precision is required.
This is a simple sliding switch ready to plug on a protoboard or a breaboard.
Simple 5mm red led with 25mcd power.
This is a simple Schottky Rectifier Diode rated at 1A, a must for a lot of projects.
barrel jack This is a DC Jack 5.5/2.1 to screw terminals adapter. It is ideal to connect standard power supplies to your project, led panels, strips or whatever.