dc-dc input 12V / output 5V and 3.3V 6A (stepdown)

Electrogragon
ENETAO12V335
€6.00

DC-DC input 12V / output 5V and 3.3V 6A Modul

You might also like

HackSpark
  1. All our products are shipped from France.
  2. A doubt about a purchase ? Return your items and get money back.
  3. We carefully choose and test the products we sell.

Module, input 12V / output 5V and 3.3V 6A ( KIW 3312S )

18 Items
New product
No reviews

Customers who bought this product also bought:

  • Reduced price / -€1.00
Available
Wireless Connectivity

ESP-01S WiFi Serial Transceiver Module with...

SEDWIFSERTRNESP
€4.00 €5.00
This is the pin compatible upgrded version of the ESP-01 chip. ESP8266 is a highly integrated chip designed for the needs of a new connected world. It offers a complete and self-contained Wi-Fi networking solution, allowing it to either host the application or to offload all Wi-Fi networking functions from another application processor.   ESP8266 has...
Available
Electronics

Infrared Kit - IR Receiver (HS0038) + IR LED...

IRELDRECTRANS
€0.79
hs0038 IR sensor tuned to 38KHz, perfect for receiving commands from a TV remote control. Runs at 5V (although it seems to be OK down to 3.3V)To use, connect pin 3 (all the way to the right) to 5V power, pin 2 (middle) to ground and listen on pin 1. It doesn’t do any decoding of the signal, just passes the ‘raw data’ along.
2
Available
Electronics

8 Channel 5V Relay Module (5V, 250VAC/10A)

RELITD8CH5V
€16.00
This is a 5V 8-Channel Relay module, It can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM and MSP430.
2
Available
Display

LCD IIC Interface Converter Board

MODJANBOARD1602
€3.25
Simply the interface of 1602 to IIC, save more IOs, with this board you only need two IOs. This board is also supporting 2004A which is also available in our store.
2
  • Reduced price / -€3.00
Available
Electronics

Bread Board Power Supply Shield (5V/3.3V...

ENEITEBREPOW
€4.50 €7.50
This is a power module for the standard bread boards (Small and Medium sized). It's concave design so will not wast your proto zone. It also supports both 5v and 3.3v (both can be enabled on each power rail). We think it is a must to have on your workbench, really.
2
Available
Dev. Tools

Screw Shield with Protoboard (Aduino Compatible)

ECRMCS01110
€8.33
The Screw Shield extends all pins of the Arduino out to 3.5mm pitch screw terminals. It also has a lot of the utility provided by Arduino Protoshield, including: a large prototyping space of both connected and unconnected 0.1" spaced through-holes, a couple 5V and GND busses, a reset button, and a 5mm green LED.
2
Available
Electronics

DRV8825 stepper motor driver with heat sink...

MDRDRV8825
€6.25
This product is a carrier board or breakout board for TI’s DRV8825 stepper motor driver; we therefore recommend careful reading of the DRV8825 datasheet (1MB pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2.2 A output current per coil (see the Power Dissipation Considerations section below for...
Product added to wishlist
Product added to compare.