Your cartThere are no more items in your cart
Batteries Case Holder Single Side 1X 18650
With spring load design, you can easily to put the battery 18650.
Customers who bought this product also bought:
Battery holder for 1x18650
This is a T-Cobbler breakout kit used for extending the GPIO interface on Raspberry Pi B+,2 3 4 to breadboard. It helps you to make the connections between Raspberry Pi B+/2/3/4 breadboard become simple.
This is a simple to use voltage régulator that outputs 3.3V at 0.8A AZ1117
SIM 800L est un module mini-GSM qui offre des données GSM 2G et GPRS. Désormais également en pack avec la carte SIM ThingsMobile. Le module a une petite taille et une faible consommation d'énergie. Deux fois la taille d'une pièce et 1 mA en mode veille. Il utilise une interface de communication série, prend en charge les commandes 3GPP TS 27.007, 27.005...
This is a splittable 40 pin dual female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
The minimal design approach to EDArduino, and fully compatible with arduino. This is a 5V EDArduino running the 16MHz bootloader (select ‘Arduino pro mini′ within the Arduino software). EDArduino Pro Mini does not come with connectors populated so that you can solder in any connector or wire with any orientation you need. We recommend first time EDArduino...
Simple step-down module to use an higher voltage as a sorce for a circuit needing a lower one.
Motors and Servos
The best battery connectors on the market just got better with the development of the XT60H, also called the XT60+. The new XT60H features snap on insulating end caps which provide extra grip and heart-shrink free installation. They also have a design change which is far more user-friendly for connection and disconnection with an improved integrated grip...