Your cartThere are no more items in your cart
Weight Sensor (Load Cell) 0-500g
Applicable to electronic scale, price computering scale, electronic platform scale, digital scale; parcel post scale, electronic balance and all varieties of commercial scales by single load cell.
Capacity g 500g
Output sensitivity mv/v 0.5±0.1
Nonlinearity %.F.S 0.05
Hysteresis %F.S 0.05
Repeatability %F.S 0.05
Creep(30min) %.F.S 0.05
Temperature effect on sensitivity %F.S/10℃ 0.05
Temperature effect on zero %F.S/10℃ 0.05
Zero balance %F.S ±0.5
Input resistance Ω(ohms) 1120±10
Output resistance Ω(ohms) 1000±10
Insulation resistance MΩ(ohms) ≥2000
Recommended excitation voltage v 5v
Method of connecting wire red： Exc + black： Exc –
green： Sig + white：Sig -
Customers who bought this product also bought:
This is a splittable 40 pin jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
The reed switch is an electrical switch operated by an applied magnetic field. When the device is exposed to a magnetic field, the two ferrous materials inside the switch pull together and the switch closes. When the magnetic field is removed, the reeds separate and the switch opens. This makes for a great non-contact switch. It consists of a pair of...
High power mosfet to switch all your devices/leds/motors easily. This is the N-type, meaning you have to put it between the load and the ground.
The ITDB02 LCD modules works in 3.3V voltage level and are not compatible with Arduino pins, for that reason, this Arduino shield connects with these LCDs. Now you can directly plug the ITDB02 Series LCDs in the shield and stand on the Arduino board.
A little Bluetooth 4.0 USB Adapter at a great price.
This aplifier allows you to use weight sensors of all kinds.
Nice cable with a good section, when you need more power.
Blend Micro is Red Bear's first integrated developement board, we have "blend"ed Arduino with Bluetooth 4.0 Low Energy (aka BLE or Bluetooth Smart) into a single board. It is targeted for makers to develop low power Internet-Of-Things (IoT) projects quickly and easily. The micro-controller unit (MCU) is Atmel ATmega32u4 and the BLE chip is Nordic...
“An open-source firmware and development kit that helps you to prototype your IOT product within a few Lua script lines” Based on ESP8266 ESP12E wifi board, on-board USB-TTL support directly flashing from USB port, also on-board power circuits and all IOs setup.