Your cartThere are no more items in your cart
Grove Touch Sensor/Button Brick
Electronic Brick - Touch Sensor/Button Brick
Customers who bought this product also bought:
LED 128×64 Display module is an OLED monochrome 128×64dot matrix display module with Grove 4pin I2C Interface .The characteristics of this display module are high brightness, self-emission, high contrast ratio, slim outline, wide viewing angle, wide temperature range, and low power consumption. It has bigger screen and uses all the columns from the...
This is a common female barrel jack connector for pcb or cable mounting. 2,1mm inner pole, 5 to 5.5mm outside.
Chainable RGB LED Twig is based on P9813 chip which is a full-color light source LED driver chip, can provide constant current drive and modulated output of 256 gray. Transmission by wire (DATA and CLK), built-in recycling, can enhance the transmission distance.
Very bright yet low-power rgb led, common anode flavor (easier to use in arrays).
A simple 50k ohm vertical linear potentiometer for all your projects.
This is a T-Cobbler breakout kit used for extending the GPIO interface on Raspberry Pi B+,2 or 3 to breadboard. It helps you to make the connections between Raspberry Pi B+/2/3 breadboard become simple.
This is a splittable 40 pin jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.