It's a small breakout board for the ENC28J60 Ethernet chip. Contains all the necessary hardware to implement an Ethernet interface including the isolation transformer and LINK/STATUS and power LEDs. SPI interface makes this one of the easiest 10Base-T ICs yet. It's 3.3V with 8KB buffer.
Output Power: Min 2.5mW, Typical 3.0mW, Max 5.0mW
Working current: Min 10mA, Typical 20mA, Max 25mA
Working voltage: Min 2.3VDC, Typical 4.5VDC, Max 8.0VDC
Working Temperature: Min -15C, Typical 25C, Max 35C
Storage Temperature: Min -20C, Max +25C
Focused Dot width: <2mm spoting 3 meters away.
This is a splittable 40 pin male-female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Foca is a FT232RL breakout. The FT232RL is a USB to serial UART interface with optional clock generator output. It’s the essential tools for establishing communication between PC and mostly MCU. Especially, it’s the optimum tool for basic boards without without USB interface, like arduino pro, colorduino, etc.
The good point is that it also...
Tap to zoom
You need to login or create account
Save products on your wishlist to buy them later or share with your friends.