DHT-11 Temperature & Humidity Sensor
This sensor provides temperature and humidity data with a quite good sensibility in a serial format thanks to its built-in micro-controller.
- Full range temperature compensated
- Relative humidity and temperature measurement
- Calibrated digital signal
- Outstanding long-term stability
- Extra components not needed
- Long transmission distance
- Low power consumption
- 4 pins packaged and fully interchangeable
Customers who bought this product also bought:
Simply the interface of 1602 to IIC, save more IOs, with this board you only need two IOs. This board is also supporting 2004A which is also available in our store.
The RS232 to TTL UART MAX3232 converter module is widely used in radio modifications,phone flash, XBOX360 flash, GPS, vehicle detection, DVD flash, hard disk repair set-top box upgrade. It can be used to program STC MCU, NXP MCU,Renesas MCU, STM32 MCU, N+-2EC MCU.
As an expansion board, Base Shield v2 has many Grove connectors, making it convenient for you to use Grove products together. And It is compatible with a series of Arduino products.
Power and Energy
The LiPo Charger is extremely affordable and easy to use. No programming is required. Plug it in and it works. The internal charger IC handles all the power flow between the various components.
The Uno is a microcontroller board based on the ATmega328 and compatible with the Arduino Uno R3. It has 14 digital I/O pins, 6 analog inputs, a 16MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or...
This is a splittable 40 pin dual female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
High quality pliers
Mainly used in Air Conditioner Louver , Small Cooling/Heating Fan etc., Stable and all technic parameters are qualified for national electronic standard of SJ/T10689-95
The purpose of this design is for learning how to play with the hardware and software of a IOT project, it is based on price competitive wifi module ESP8266.
The very popular 595 shift register chip of the 74 series is used a lot by hobbyis because of its wide availability, good speed and simplicity. Just plug it on an arduino like shown in the tutorials and youi have 8 more outputs, put two and you have 16 more outputs ! (up to a lot of them actually, with only three pins !)