28BYJ-48 High quality Stepper motor 5V
€3.50 €7.00 -€3.50
Mainly used in Air Conditioner Louver , Small Cooling/Heating Fan etc., Stable and all technic parameters are qualified for national electronic standard of SJ/T10689-95
- Rated voltage 5VDC
- Number of Pole 4
- Speed Variation Ratio 1/64
- Stride Angle 5.625° /64
- DC resistance 200Ω±7%(25℃)
- Idle In-traction Frequency >600Hz
- Idle Out-traction Frequency >1000Hz
- In-traction Torque >34.3mN.m(120Hz)
- Self-positioning Tor >34.3mN.m
- insulated resistance >10MΩ(500V)
- insulated electricity power 600VAC/1mA/1s
- Insulation grade A
- Rise in Temperature <40K(120Hz)
- Noise <40dB(120Hz,No load,10cm)
Customers who bought this product also bought:
Description This is essentially a ramped up version of our Ardumoto motor driver shield. For this monster shield we’ve replaced the L298 H-bridge with a pair of VNH2SP30 full-bridge motor drivers. We’ve also beefed up the support circuitry so this board is capable of driving a pair of high-current motors! The VIN and motor out are pitched for our 5mm...
This is a splittable 40 pin dual male jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse. EasyDriver requires a 7V to 30V supply to power the motor and can power any voltage of stepper motor. Connect a 4-wire stepper motor and a microcontroller and you've got precision motor control! EasyDriver drives bi-polar motors, and...
It is very practical for Li-Po battery.
DC 5V 3A This small yet powerful 5V DC 3A USB power module provides your mini-computers (only iuse on compliant devices !) an easy to use power supply.
Senses when a door or window is open or closed... Perfect for use with your favourite micro controller board (be it arduino, launchpad, stm3é or whatever) !
This is a T-Cobbler breakout kit used for extending the GPIO interface on Raspberry Pi to breadboard. It helps you to make the connections between Raspberry Pi and breadboard become simple.
Wires and Connectors
Manufacturer WAGO Type of splice terminal installation quick splice Electrical mounting spring clamp Wire cross section 0.2...4mm2 Connector series 221 Mechanical mounting for cable Rated voltage 450V Current rating 32A Number of ways 1 Number of terminals 5 Connector variant with lever
BeagleBone Black is the newest member of the BeagleBoard family and is a lower-cost, high-expansion focused BeagleBone, featuring the Sitara AM3359 ARM Cortex-A8 32-Bit RISC microprocessor from Texas Instruments. It is similar to the BeagleBone but with some previous features removed to make way for the excellent new features.
High power mosfet to switch all your devices/leds/motors easily. This is the N-type, meaning you have to put it between the load and the ground.