Your cartThere are no more items in your cart
DC 5V 8A Power supply (5.5mm/2.1-2.5mm Barrel Jack)
This small yet powerful 5V DC 8A power module provides all your projects an easy to use power supply.
- 1st side :
- Tri-wire main line power connector (like a computer one, not supplied)
- 2nd side :
- Barrel jack adapter 5.5/2.5mm (has springs, compatible with 2.1mm too)
Max power: 48W
Current: 5V 8A
Customers who bought this product also bought:
RGB LED Matrix Panel Drive Board RTC Direct For Arduino UNO
High power mosfet to switch all your devices/leds/motors easily. This is the P-type, meaning you have to put it between the load and the ground.
Main Boards and Compatible
Very nice miniature dev board for all your miniature usb needs :-).
Battery holder for 1x18650
Power and Energy
This is a custom solar panel, which mates directly with many of our development boards and has a high efficiency at 16%. Unit has a clear epoxy coating with hard-board backing. Robust sealing for out door applications! solar
Q Oil Q30 Protective Removable Film Spray
Latest Arduino sensor Shield V5.0 reserves advantages of Arduino Sensor V4.0,such as lamination design, PCB immersion god process, and main board extend all the figures and analog interfaces of Arduino controller. I2C interface, 32 steering engineer controller interface, Bluetooth module communication interface ,SD card module communication interface,...
This 32 x 32 square RGB LED matrix panel could bring the most luminous city of the world to your home or shop. This panel has 1024 bright RGB LEDs 32x32. On the back there is a PCB with a set of dual IDC connectors (one input, one output: in theory you can chain these together) and 12 16-bit latches that allow you to drive the display with a 1:16 scan rate.
Nice little red matrix with easy-to-use backpack included
This is a splittable 40 pin male-female jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.