DC Power Female Jack Adapter ( barrel jack Screw terminals)

ENECONBARSCR
€1.50

barrel jack This is a DC Jack 5.5/2.1 to screw terminals adapter. It is ideal to connect standard power supplies to your project, led panels, strips or whatever.

You might also like

HackSpark
  1. All our products are shipped from France.
  2. A doubt about a purchase ? Return your items and get money back.
  3. We carefully choose and test the products we sell.

Input : 5.5mm/2.1mm Jack Output : Screw terminals

96 Items
New product
No reviews

Customers who bought this product also bought:

2
Available
Electronics

DRV8825 stepper motor driver with heat sink...

MDRDRV8825
€6.25
This product is a carrier board or breakout board for TI’s DRV8825 stepper motor driver; we therefore recommend careful reading of the DRV8825 datasheet (1MB pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2.2 A output current per coil (see the Power Dissipation Considerations section below for...
Available
Raspberry Pi

Raspberry Pi B+/2/3 Enclosure - Black

CASRPI2BLK
€6.25
It is a good plastic box for Raspberry Pi, which can protect it with one of these snazzy plastic enclosures?. These cases protect the Raspberry Pi from things like rogue wires that might short it out while still allowing full access to the board! Simply snap the RPi into the bottom half of the enclosure, then snap the two sides together. The e
2
Available
Motorized

Gear Set (motor + tire)

MOTCARGEARTIRE
€4.00
Very simple ready to use set, ideal to use in small micro-controller vehicles.
2
Available
Electronics

Grove - DMX512

CONGRODMX512
€8.00
The Grove – DMX512 is a adapter from Grove interface to DMX512 interface(industry standard EIA-485 interface. The module is based on SN75176 chip which can balance transmission lines and meet ANSI Standard EIA-485 interface. Now It is convenience to control stage lighting and DMX512 console for Arduino.
Available
Grove

Grove - Infrared Emitter

SEDGROIREMI
€4.00
The Infrared Emitter is used to transmit infrared signals through an infrared LED, while there is an Infrared receiver to get the signals on the other side . An infrared LED is like any other LED, with its color centered around 940nm. We can use the emitter not only to transmit data or commands, but also to emulate remotes to control your home appliance...
Available
Power and Energy

4.5W Solar Panel 165X165

ENTAO4.5W
€12.00
solar panel is made of single-crystal material that performs high solar energy transformation efficiency at 17%. It has a fine resin surface and sturdy back suitable for outdoor environments. A 2mm JST connecter is attached to the penal, which makes it perfect to team up with most of our can-use-solar-power-supply boards.
Product added to wishlist
Product added to compare.