- Out-of-Stock
- Motorized
- Tools
-
Dev. Tools
-
Electronics
- Power and Energy
- Wires and Connectors
- Grove
- USB Peripherals
- Motors and Servos
- LEDs & Lights
- Assembly kits
- Domotic
- Break-out Boards
- Network
- Electronic basics
- PCBs
- Sound
- Integrated Circuits (ICs, Chips)
- Wireless Connectivity
- Sensors
- Human Interface
- CMS / SMD
- Others
- Prototyping
AD597ARZ - Temperature sensor IC, Voltage, ± 4 ° C, -40 ° C, +125 ° C, SOIC, 8 Pin (CMS SMD )
€12.00
Tax included
The AD597ARZ is a monolithic temperature Set-point Controller which has been optimized for use at elevated temperatures such as those found in oven control applications. The device cold junction compensates and amplifies a type J or K thermocouple input to derive an internal signal proportional to temperature. The internal signal is then compared with an externally applied set-point voltage to yield a low impedance switched output voltage. Dead-Band or switching hysteresis can be programmed using a single external resistor. Alternately, this can be configured to provide a voltage output (10mV/°C) directly from a type J or K thermocouple signal. It can also be used as a stand-alone voltage output temperature sensor.
| Type d'alimentation | Simple |
| Type de boîtier | SOIC |
| Type de montage | CMS |
| Tension d'alimentation asymétrique typique | 5 30 V |
| Nombre de broche | 8 |
| Rail à rail | Non |
| Température de fonctionnement minimum | -55 °C |
| Température d'utilisation maximum | +125 °C |
| Produit gain bande typique | 15kHz |
| Longueur | 5mm |
| Dimensions | 5 x 4 x 1.5mm |
| Largeur | 4mm |
You might also like
The AD597ARZ is a monolithic temperature Set-point Controller which has been optimized for use at elevated temperatures such as those found in oven control applications. The device cold junction compensates and amplifies a type J or K thermocouple input to derive an internal signal proportional to temperature. The internal signal is then compared with an externally applied set-point voltage to yield a low impedance switched output voltage. Dead-Band or switching hysteresis can be programmed using a single external resistor. Alternately, this can be configured to provide a voltage output (10mV/°C) directly from a type J or K thermocouple signal. It can also be used as a stand-alone voltage output temperature sensor.