Your cartThere are no more items in your cart
Lithium Battery Charger Board MCP73831T Lipo
Complete constant-current/constant-voltage linear charger for single cell lithium-ion batteries.
- For 3.7V battery charge
- Linear charging current 500mA
- Use microUSB jack, please be aware to plug in and out gentle.
- On board XH2.54 jack, and standard 2.54mm pin holes
- On board status LED:
- Blink: USB input power connected, no battery connected
- On: Charging
- Off: Charged, or can not charge due to wrong connection
- Compact size
- Simple peripheral circuits, schematic
Customers who bought this product also bought:
Have you ever want to DIY an Aquarium controllers to help you Changing the water for the fish tank. This mini pump really sucks! This pump operates at 3V~9V and has enough suction for most small projects. Use this pump to make a fountain or waterfall, even water your plants!
LM386 Audio Amplifier Module 20 Times 4V-12V 8 - 32 Ohms / Input 10K Adjustable Resistance.
Input with MICRO USB female, can directly use mobile charger for input to the lithium battery.And still retain the input voltage wiring solder joints, can be very convenient to DIY.
This is a light weight, high energy density polymer lithium battery. It outputs a nominal 3.7v at 980mAh, including built-in protection against over voltage, over current, and minimum voltage. It comes terminated with a standard 2-pin JST connector-2.54 mm spacing between pins. Please do not attempt to charge these with anything but a specialized Lithium...
The Uno is a microcontroller board based on the ATmega328 and compatible with the Arduino Uno R3. It has 14 digital I/O pins, 6 analog inputs, a 16MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or...
It's a small USB to TTL serial tool, using the PL2303 chip. You can use it to connect some serial device to your PC via USB port, an avr, an msp430 or an stm32 for example. It's very cheap compared to the ft232 alternative and works very well, up to more than 1mbit/s.
The LilyPad Arduino USB is a microcontroller board based on the ATmega32u4 (datasheet). It has 9 digital input/output pins (of which 4 can be used as PWM outputs and 4 as analog inputs), an 8 MHz resonator, a micro USB connection, a JST connector for a 3.7V LiPo battery, and a reset button. It contains everything needed to support the microcontroller;...
Standard size breadboard that is perfect for prototypes. It does even have power rails on the sides to allow for more than one power level. The one you will get is white and not transparent as in the picture.Breadboard
Screw shield is a wing-like shield that extends both sides of your Arduino or Arduino variants into sturdy and reliable screw terminal blocks.