Your cartThere are no more items in your cart
8mHz Crystal Oscillators HC-49S Quartz Low Profile rc pi arduino
Customers who bought this product also bought:
The high-performance, low-power Atmel 8-bit AVR RISC-based microcontroller combines 8KB ISP flash memory, 512B EEPROM, 512-Byte SRAM, 6 general purpose I/O lines, 32 general purpose working registers, one 8-bit timer/counter with compare modes, one 8-bit high speed timer/counter, USI, internal and external Interrupts, 4-channel 10-bit A/D converter,...
Support Micro SD card(<=2G), micro SDHC card(<=32G)Interface level: 5V or 3.3VPowr supply: 4.5V to 5.5V , 3.3V voltage regulator circuit boardCurrency: 0.2-200mACommunication interface: SPIWith 4 holes for M2 screw. Easy to install
The Arduino Ethernet Shield allows an Arduino board to connect to the internet. It is based on the Wiznet W5100 ethernet chip. The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield. The...
20 pin double wipe integrated circuit pcb socket. (DIP20 )
ATMega328 32K microcontroller with pre-loaded Arduino UNO bootloader
he level converter is very easy to use. The board needs to be powered from the two voltages sources (high voltage and low voltage) that your system is using. High voltage (5V for example) to the ‘HV' pin, low voltage (3.3V for example) to ‘LV', and ground from the system to the ‘GND' pin.
USB Micro-B Connector Breakout Board