• Reduced price

12VDC Medium Size Water Pump 6W

MOTWPUMP6W
€6.50 €12.50 -€6.00

Have you ever want to DIY an Aquarium controllers to help you Changing the water for the fish tank. This mini pump really sucks! This pump operates at 12V and has enough suction for most small projects. Use this pump to make a fountain or waterfall, even water your plants!

You might also like

HackSpark
  1. All our products are shipped from France.
  2. A doubt about a purchase ? Return your items and get money back.
  3. We carefully choose and test the products we sell.

Specifications:

  • Operating voltage: DC 12V
  • No load current: 0.23 A
  • Load: 450 mA
  • Maximum flow: 2-3 liters/minute
  • Outlet pressure: 1-2.5 kg
  • The highest lift: 1-2.5 meters
  • Normal working time: 2-3 years.
  • Maximum suction: 2 meters
  • Inlet and outlet diameter: outside diameter 8mm
  • Motor length: 32MM
  • Motor diameter: 28MM
  • Pump length: 36MM
  • Total length: 69MM
  • Pump diameter: 40MM*35MM
3 Items
New product
No reviews

Customers who bought this product also bought:

2
Available
Dev. Tools

NodeMCU Lua Lolin V3 Module ESP8266 ESP-12F...

WIRNODMCUV3
€8.25
“An open-source firmware and development kit that helps you to prototype your IOT product within a few Lua script lines” Based on ESP8266 ESP12E wifi board, on-board USB-TTL support directly flashing from USB port, also on-board power circuits and all IOs setup.
2
Available
Raspberry Pi

Raspberry Pi Pico

LINRPIPICO
€5.17
Le premier microcontrôleur Raspberry Pi en silicium avec Puce RP2040 Programmation en C / C ++ et MicroPython Processeur ARM Cortex M0 + double cœur - 133 MHz avec 264 Ko de SRAM et 2 Mo de mémoire Flash intégrée 26 broches GPIO multifonction 2 × SPI, 2 × I2C, 2 × UART, 3 × ADC 12 bits, 16 × canaux PWM contrôlables
2
Available
Electronics

DSUN Mini Adjustable DC-DC Step down , in 4.5V...

ENEELDMINDCSD
€3.33
Step-down switching power supply rated for up to 3A.We recommend keeping it under 1.8A without reasonable cooling. It has an adjustable voltage level from 0.8V ~ 20V so will handle the usual 3.3v, 5v, 6v, 12v etc
2
Available
Electronics

Mini Water Pump 2.5 – 6V 0.5W

MOTMINIWATPUMP
€5.42
Have you ever want to DIY an Aquarium controllers to help you Changing the water for the fish tank. This mini pump really sucks! This pump operates at 3V~9V and has enough suction for most small projects. Use this pump to make a fountain or waterfall, even water your plants!
2
  • Reduced price / -€0.60
Available
Electronic basics

Small Breadboard (8x6, "Half-size")

PCB00002
€3.98 €4.58
Half size breadboard that is perfect for small prototypes. It does even have power rails on the sides to allow for more than one power level.
  • Reduced price / -€1.50
Available
Electronics

1 Channel 5V Relay Module (5V, 250VAC/10A)

REL1CH5V
€2.67 €4.17
This is a 5V 1-Channel Relay module, It can be controlled directly by a wide range of microcontrollers such as Arduino, AVR, PIC, ARM and MSP430.
Available
Electronics

0.1" (2.54mm) Female header 1 row / 40 pins

CONGENFEM40
€0.92
This is a simple female header, very useful for a lot of things, including to plug boards like the stm32f4 discovery or the arduino nano on your protoboards.
2
Available
Gaz / Volatile

Analog CO / Combustible Gas Sensor (MQ-9)

SENJANCOGAS
€4.50
MQ-9 The Analog CO/Combustible Gas Sensor(MQ9) module is useful for gas leakage detecting, it used the sensitive material SnO2, which with lower conductivity in clean air. It make detection by method of cycle high and low temperature, and detect CO when low temperature (heated by 1.5V). The sensors conductivity is more higher along with the gas...
2
Available
Electronics

Dual male splittable jumper wires (200mm 40...

CONSEDJMP40P20
€4.17
This is a splittable 40 pin jumper wire, it is super flexible, can be transformed from 1-40 pin jumper wire. With some of these, you will no need to worry about the jumper wires you got before do not fit your project, just split it and go.
Product added to wishlist
Product added to compare.