• New

AC-DC 5V 2A 10W Power Module

ENEADA5V2AMOD
€7.00
Tax included

This small yet powerful 5V DC 2A  power module provides all your  projects an easy to use power supply.

You might also like

HackSpark
  1. All our products are shipped from France.
  2. A doubt about a purchase ? Return your items and get money back.
  3. We carefully choose and test the products we sell.

Description

This power supply is fully isolated industrial internal power module with temperature protection, overcurrent protection and short circuit full protection, AC85 ~ 265V wide voltage input, high and low voltage isolation, DC12V1A output voltage, 431 regulated output with EMI filter circuit, with status LED, with installation holes, cost-effective.

Features:

  • Input (full load): AC 85-265V or DC 100v-370v
  • Input current (full load): 0.027(AC110V) 0.0136(AC220V)
  • Input inrush current (full load): 20A
  • Output: 5V, 0-2A, 2.2A max, output voltage range 4.8-5.2V, 60mV voltage wave
  • DC output power: 10W
  • Efficiency: 80%
  • On/off overload range: 10%
  • Output upward time: 100ms
  • Size: 6.6*3.0*2.1 CM
  • Pin Definition one side marked AC N, AC L, and another side is 5V, gnd.
  • On board status LED

Protection: overload, short circuit, overheat, over-current protection. Board will lock and recover when turn it on/off.

Reliability: Environment 25 ℃, at 80% load MTBF more than 16,000 hours

6 Items
New product
No reviews

Customers who bought this product also bought:

2
Available
Electronics

Mini Water Pump

MOTMINIWATPUMP
€9.00
Have you ever want to DIY an Aquarium controllers to help you Changing the water for the fish tank. This mini pump really sucks! This pump operates at 3V~9V and has enough suction for most small projects. Use this pump to make a fountain or waterfall, even water your plants!
Available
Electronics

Infrared Kit - IR Receiver (HS0038) + IR LED...

IRELDRECTRANS
€0.96
IR sensor tuned to 38KHz, perfect for receiving commands from a TV remote control. Runs at 5V (although it seems to be OK down to 3.3V)To use, connect pin 3 (all the way to the right) to 5V power, pin 2 (middle) to ground and listen on pin 1. It doesn’t do any decoding of the signal, just passes the ‘raw data’ along.
Product added to wishlist
Product added to compare.