D-duino can be programed like Arduino. It has a display(0.96 inch OLED) so I call it D-duino. Also you can use LUA control this board like NodeMCU. You can understand this is NodeMCU+OLED. I think the 0.96″ OLED will be very helpful for makers to develop IOT.
“An open-source firmware and development kit that helps you to prototype your IOT product within a few Lua script lines” Based on ESP8266 (wi07-7) wifi board, on-board USB-TTL support directly flashing from USB port, also on-board power circuits and all IOs setup.
This is a standard solderless breadboard - three binding posts, 4 power buses, black aluminum plate backing. It works with a wide variety of wire gauges (29-20 AWG). With a total of 1660 tie in points, all pins are spaced by a standard 0.1".
Tap to zoom
You need to login or create account
Save products on your wishlist to buy them later or share with your friends.