ADS1115 16bits ADC+PGA Breakout Board

CONELE1115
€5.00
ADS1115 16bits ADC+PGA Breakout Board

You might also like

HackSpark
  1. All our products are shipped from France.
  2. A doubt about a purchase ? Return your items and get money back.
  3. We carefully choose and test the products we sell.

Product Description

  • Wide supply range VDD : 2-5.5V
  • Low Power consumption:
    • Continuous Mode: Only 150µA
    • Single-Shot Mode: Auto Shut-Down
  • Programmable data rate: 8-860 SPS (samples/second)
  • Internal Low drift voltage reference
  • Internal oscillator
  • Internal PGA (programmerable gain amplifiter,  up to x16)
  • I2C interface connection, pin address configurable, 7-bit addresses between 0x48-0x4B, (see the datasheet table 5)
  • Four single ended, or two differential inputs
  • Programmable comparator

Documentation please see on this page.

Zone de stockage
Etage de rangement
Display Type
Type de composant
Résolution d'affichage
Google Product Type
Colonne de rangement
Code Fabricant
Couleurs d'affichage
Package
Voltage
2.5v,2v,3.3v,5v,6v
New product
No reviews

Customers who bought this product also bought:

2
Available
Dev. Tools

Arduino UNO Rev 3 ( R3 )

MCB00003
€20.83
This is the official current Arduino board, top quality, made in Italy and with a Zero Carbon Footprint!The Arduino Uno is a microcontroller board based on the ATmega328 (datasheet). It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and...
Available
Electronics

Lithium Polymer Battery - 980mAh 3.7V

ENEBATLP573450
€10.00
This is a light weight, high energy density polymer lithium battery. It outputs a nominal 3.7v at 980mAh, including built-in protection against over voltage, over current, and minimum voltage. It comes terminated with a standard 2-pin JST connector-2.54 mm spacing between pins. Please do not attempt to charge these with anything but a specialized...
2
Available
Electronics

DRV8825 stepper motor driver with heat sink...

MDRDRV8825
€6.25
This product is a carrier board or breakout board for TI’s DRV8825 stepper motor driver; we therefore recommend careful reading of the DRV8825 datasheet (1MB pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2.2 A output current per coil (see the Power Dissipation Considerations section below for...
2
  • Reduced price / -€3.50
Available
Dev. Tools

FunDuino UNO (ATMega 328P board compatible with...

MCBFUNUNO
€12.50 €16.00
The FunDuino Uno is a microcontroller board based on the Arduino UNO. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer...
Available
Electronic basics

Medium (Basic) Breadboard ( White, 16.5*5.5 cm...

PCB00008
€5.00
Standard size breadboard that is perfect for prototypes. It does even have power rails on the sides to allow for more than one power level. The one you will get is white and not transparent as in the picture.
Available
Electronics

4 Channel Logic Level Converter Bi-Directional...

CNVJAN4CH
€2.00
he level converter is very easy to use. The board needs to be powered from the two voltages sources (high voltage and low voltage) that your system is using. High voltage (5V for example) to the ‘HV' pin, low voltage (3.3V for example) to ‘LV', and ground from the system to the ‘GND' pin.
2
Available
Electronics

PC817 4 PIN Opto-coupler PHOTOTRANSISTOR...

ECJTAOPC817
€0.40
PC817/EL817  4pin  DIP  General Purpose Photocoupler. This Opto-coupler consist of one piece of Ga as emitter and one piece of NPN transistor.
Product added to wishlist
Product added to compare.