74HC595 Shift-Register (DIP)

Texas Instruments
ELC74HC595
€1.20

The very popular 595 shift register chip of the 74 series is used a lot by hobbyis because of its wide availability, good speed and simplicity.
Just plug it on an arduino like shown in the tutorials and youi have 8 more outputs, put two and you have 16 more outputs ! (up to a lot of them actually, with only three pins !)

Quantity Discount You Save
2 €0.44 Up to €0.88
10 €0.70 Up to €7.00
25 €0.80 Up to €20.00

You might also like

HackSpark
  1. All our products are shipped from France.
  2. A doubt about a purchase ? Return your items and get money back.
  3. We carefully choose and test the products we sell.

For more information, have a look at :

26 Items
New product
No reviews

Customers who bought this product also bought:

2
Out of stock
Tools

Raspberry Pi B+/2/3 Enclosure - Transparent /...

CASRPI2CLR
€6.25
It is a good plastic box for Raspberry Pi, which can protect it with one of these snazzy plastic enclosures?. These cases protect the Raspberry Pi from things like rogue wires that might short it out while still allowing full access to the board! Simply snap the RPi into the bottom half of the enclosure, then snap the two sides together.
View
  • Reduced price / -€0.80
Available
Electronics

LDR Photo-resistor

SENRSLDR
€0.70 €1.50
Basic photo-resistor.
2
Available
Electronics

DHT-11 Temperature & Humidity Sensor

SENDHT11
€2.50
This sensor provides temperature and humidity data with a quite good sensibility in a serial format thanks to its built-in micro-controller.
2
Out of stock
Arduino

2.4" TFT Touch shield for Arduino (Arduino...

ASHITELCD24LCDTOUCH
€24.17
The 2.4”TFT with Touch Shield is designed for all the Arduino compatible boards. It works in 3.3V voltage level (but with necessary switches from arduino 5v). It can be directly plugged on the Arduino and other compatible boards. It will offer the display, touch and storage function for the Arduino board.
View
Available
Electronics

4 Channel Logic Level Converter Bi-Directional...

CNVJAN4CH
€2.00
he level converter is very easy to use. The board needs to be powered from the two voltages sources (high voltage and low voltage) that your system is using. High voltage (5V for example) to the ‘HV' pin, low voltage (3.3V for example) to ‘LV', and ground from the system to the ‘GND' pin.
Product added to wishlist
Product added to compare.